周立功ZLG_LPC213X的全套资料，这个是其中的UART,串口编程

用LPC2106做的ARM开发板-do with the LPC2106 ARM development board

msp430 读写铁电存储器fm25L256元程序，调试通过，可用-MSP430 literacy fm25L256 ferroelectric memory element program, debug, through which can be used

S3C2440 Nor FLASH读写示例，用于ADS编译器

STM32  SYSTICK 配置 RAM运行 改动网上的源代码，可以在RAM中运行

开发环境:ADS 1.2/SDT 2.51 GUI测试，由于没有触摸屏，所以将触摸屏的代码给屏蔽了； 请将FS44B0II开发板连接好交叉网线、直连串口线、电源， 并连接好G57液晶屏，同时还要连接好背光电源； 然后在BIOS的命令窗口里面敲netrun命令； 点击FS44B0_G57_uCGUIuC-GUIFS44B0_G57_uCGUI_DataDebugRel目录下： 批处理文件FS44B0_G57_uCGUI.BAT 下面你就可以看到液晶屏上面显示优龙标志 它会延时一两秒中进入下一个画面，逐步延时GUI的各项功能，请耐心观看； -Development Environment: ADS 1.2/SDT 2.51GUI test, because there is no touch screen, it will be touch screen to shield the code Please FS44B0II development board to connect a good cross-network lines, direct serial lines, power supply, and connect a good G57 LCD screen, at the same time, good backlight power supply connection and then in the BIOS command window knock netrun order Click FS44B0_G57_uCGUIuC-GUIFS44B0_G57_uCGUI_DataDebugRel directory: batch file FS44B0_G57_uCGUI.BAT below you can see the LCD screen above shows excellent signs that it will delay Liuzhou 1 two seconds to enter the next screen, and gradually delay the GUI features, please be patient watch

ISP116X_STRONGARM_WINCE_INSTALGUIDE-01.rar

PHYcore 的DEMO板附带的CS8900网卡驱动-PHYcore the DEMO plate attached CS8900 LAN Driver

S08例程：本程序是I2C模块的例程，所用资源为单片机内部集成总线I2C模块，所接器件为24C04-S08 routines: This procedure is routine I2C module, the resources used for the single-chip integrated I2C bus module, the access device for the 24C04

基于ads的arm―lpc2131的工程模板源码，-Ads based on the arm-lpc2131 source project templates,

使用IIC器件，作为程序存储空间，对其进行读出或执行其程序。存入如“QUANZHOU NORMAL UNIVERSITY”等自定内容，再用按键调出、显示-IIC devices to use as storage space program, it read out or carry out its proceedings. Deposited, such as