综合实验源代码－汉诺塔

C51 调试OK能跑起来的UC/OS2

此代码是我精心调试而成，内有NOKIA3310驱动，无刷电机驱动，还有UCOS嵌入式操作系统，在电路板上调试成功-This code is from my well-debug, which have NOKIA3310 driver, brushless motor drive, there are uCOS embedded operating system, the success of the circuit board debugging

LPC2294 D12 ucos-II驱动(LPC2294 D12 For uCos-II)

UCOS2 for MC9S08QE128,一个完整的移植到飞思卡尔单片机的CodeWarrior 项目文件(UCOS2 for MC9S08QE128, transplanted to a complete single-chip Freescale)

在ARM上加载ucosii实现LED的显示并进行仿真验证 。-ARM load in ucosii realize LED display and simulation.

ucos在S3C2410上针对的LCD应用-uCOS in S3C2410 application against the LCD

完成在S3C2410处理器上移植μC/OS-II内核，然后实现以下多任务： a) 控制实验箱核心板上4盏LED灯轮流亮灭； b) 将LED1连接到ARM9-2410EP增强型实验箱扩展口的DA OUT端口，通过实验箱上的键盘（比如“↑”、“↓”键）控制LED1亮暗变化，同时在超级终端显示该控制值； c) 将LED2连接到扩展口的I/O输出口，通过超级终端按键控制LED2亮灭，即按一下PC的超级终端某个键（比如回车键）LED2灭，再按LED2亮，反复循环。 -Completed the processor S3C2410 transplant μC/OS-II kernel, and then multi-task to achieve the following: a) control experiment box core board 4 bright LED lights out rotation b) will LED1 connected to the ARM9-2410EP enhanced experimental me expansion of the mouth of DA OUT port, through the experimental box on your keyboard (such as

uCOS/II下用的图形系统说明-uCOS/II under the Note graphics system

嵌入式系统设计与实例开发-基于ARM微处理器与ucosii实时操作系统（王田苗）-Embeded system design and development base in arm microprocess and ucosii RTOS(TIANMIAO WANG)

TG12864 LCD代码 在UC/OS 下 EASYRARM2100 下跑过，显示一个图形，程序在ADS1。2下运行。是个处女做，仅供参考-Source code of TG12864 LCD driver for uC/OS tested on EASYRARM2100. It can display an image on the screen. It has been tested on ADS1.2. My first program.