工作中正在用的, uCOS 的移植,本来有8个文件，我合并成4个

PDIUSBD12的固件程序可能对开发USB1.1的兄弟有用-PDIUSBD12 firmware may USB1.1 brother on the development of useful

完成在S3C2410处理器上移植μC/OS-II内核，然后实现以下多任务： a) 控制实验箱核心板上4盏LED灯轮流亮灭； b) 将LED1连接到ARM9-2410EP增强型实验箱扩展口的DA OUT端口，通过实验箱上的键盘（比如“↑”、“↓”键）控制LED1亮暗变化，同时在超级终端显示该控制值； c) 将LED2连接到扩展口的I/O输出口，通过超级终端按键控制LED2亮灭，即按一下PC的超级终端某个键（比如回车键）LED2灭，再按LED2亮，反复循环。 -Completed the processor S3C2410 transplant μC/OS-II kernel, and then multi-task to achieve the following: a) control experiment box core board 4 bright LED lights out rotation b) will LED1 connected to the ARM9-2410EP enhanced experimental me expansion of the mouth of DA OUT port, through the experimental box on your keyboard (such as

英贝特lpc1788学习板，ucosii移植源码(Ingbert lpc1788 learning board, ucosii transplant source)

是操作系统源码。uc/os-II的操作系统源码，对于学习操作系统非常的方便有效-Is the operating system source code. uc/os-II operating system source code, for learning the operating system is very convenient and effective

51下的一个操作系统源码-51 operating system source code

博创UP-NETARM2410-S实验箱源码：Exp3 DA接口实验-Fiberxon UP-NETARM2410-S experimental box source: Exp3 DA Interface Experiment

NXP LPC1788采用U盘USB_HOST实现程序升级代码，带UCOS操作系统。(NXP LPC1788 using U disk USB_HOST procedures to achieve the upgrade code, operating system with UCOS. )

说明：  lwip移植加tcpip客户端功能代码，在ucos系统基础上移植lwip，并使用raw接口进行客户端服务编写(Lwip transplantation plus tcpip client function code)

这是一个用vc6.0模拟的ucgui的源码-This is a simulated ucgui with vc6.0 source

ARM 的实例程序，在ADS下运行。运行buildall.bat生成这些例子的应用。有readme具体说明有关配置。-ARM sample program, running under the ADS. Running these examples buildall.bat generation applications. A readme specify the configuration.