包括网页

视觉暂留，编程从一个I/O口输出一扫频信号，驱动一支LED灯闪动，频率范围为10HZ~99HZ，扫描时间为30秒，在LED闪动期间观察，一旦发现无法识别LED灯闪动时，按下按键K1，立即停止输出，并将此时的信号频率显示在数码管上，该信号的周期为测试者的视觉暂留时间。-Persistence of vision, programming from an I/O port outputs a sweep signal to drive an LED light flashing, the frequency range of 10HZ ~ 99HZ, scan time of 30 seconds, the LED flashing during the observation, once found it impossible to identify the LED lights flashing, press the key K1, immediate cessation of the output, and at this time the signal frequency displayed on the digital control on the test cycle of the signal" s persistence of vision time.

2051单片机的18b20温度计。有效位数为2为，程序里面以预留出小数点位，配套3位数码管即可显示。-2051 microcontroller 18b20 thermometer. 2 for the effective number of bits, the program which in order to set aside a decimal place, supporting three digital control to display.

D/A单片机程序，供单片机爱好者参考-D/A microcontroller procedures for SCM reference lovers

st7565驱动LCD12864源代码以及经调试通过的LCD测试程序-st7565-driven debugging LCD12864 source code, and adopted by the LCD test program

ADS1100/ADS1110 C51接口程序源代码-ADS1100/ADS1110 C51 interface program source code

基于AT89C2051的照明系统控制程序，实现照明设备的自动控制。-AT89C2051-based lighting systems control procedures, to achieve automatic control of lighting equipment.

使用软件模拟Ｉ２Ｃ与ＥＥＰＲＯＭ通讯的子程序-use of software simulation I2C EEPROM communications with the subroutine

93CXX的驱动程序-93CXX driver

pc机连接单片机-pc linked MCU

为了实现高精度的水温控制，本文介绍了一种以SPCE061A单片机为控制核心、以PID算法控制以及PID参数整定相结合的控制方法来实现的水温控制系统-In order to realize high-precision temperature control, This paper introduces a single-chip microcomputer to control the core SPCE061A to PID algorithm PID control and PID control of a combination of methods to realize the temperature control system