pic控制的led灯的循环点亮模式，八个LED，高电平点亮，可用于I/O口及其它信号状态的观测。...

本文章介绍了一种AD值的线性化方法。可以应用于单片机系统的设计开发当中。在系统的硬件设计方法上，使用温度补偿的方法，使得AD转换值可实现线性化，从而可以减少了单片机软件开发当中进行非线性数据的线性化处理。-This article introduces a AD value of the linear method. Can be applied to the design of single-chip microcomputer system development. The system

用Keil　C51写的步进电机驱动程序。-A stepping motor driver program written by Keil C51.

串口通信的单片机程序51单片机串口调试程序一例-Microcontroller serial communication program 51 MCU serial debugger one cases

LED动态扫描.采用74164做为显示数据输出,使I/O口减少至两个,并且可做为驱动,是小系统LED显示的最佳方法-LED dynamic scanning. Using 74,164 as output data show that, I/O port reduced to two, but also to drive, is a small LED display system the best way

c8051f 软件读出的FLASH数据转换成二进制数据-c8051f software FLASH read out data into binary data

采用东芝TDA7495/TDA7496芯片（已经形成产品）制作的高保真立体声音频放大器PCB裸板图-Toshiba chips used TDA7495/TDA7496 (has been formed products) produced by high-fidelity stereo audio amplifier PCB bare board diagram

单片机控制的条码打印机程序,程序简单,功能齐全.-MCU-controlled bar code printer program, the program simple and functional.

详细介绍了pic单片机c语言编程的方法和技巧-detail the pic microcontroller c language programming methods and techniques

ADC0809数据采集程序，适合与51系列单片机系统。-ADC0809 data acquisition procedures, suitable for single-chip microcomputer system with 51 series.

很多8051的例子，对初学者而言，很有用！-many examples of 8051, for beginners, very useful!