MICROCHIP KEELOQ CODE HOPPING SIMPLE DECODER

凌阳单片机以SCAM_2000语音格式播放程序的编写方法-Sunplus MCU to SCAM_2000 voice format player in the preparation method

这是基于单片机的gprs编程 希望能给予大家帮助 -This is based on the MCU programming gprs hope to help everyone

可以熟悉51单片机中断机制 大大方便学习51单片机-Be familiar with the 51 single-chip interrupt mechanism would greatly facilitate study of 51 single-chip microcomputer

单片机P1口与4个按键连接，用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(-WR)与DA0832、2个741(运放)连接构成波形信号输出电路。 编程使波形信号输出电路输出正弦波信号，并且可通过操作键调节信号的幅度和频率。幅度和频率调节级别从0~10，共11个等级。 -Singlechip P1 I connect with the four buttons for the signal amplitude and frequency adjustment operation keys. Singlechip P0, P2.7, P3.6 (-WR) and DA0832, 2 months 741 (operational amplifier) to connect constitute waveform signal output circuit. Programming so that waveform signal output circuit output sine wave signal, and can be operated keys adjust the signal amplitude and frequency. Amplitude and frequency adjustment level from 0 ~ 10, a total of 11 grades.

这是一个就算波特率的软件，功能强大，在单片机通信时不用自己动手计算，只要用此软件点击一下，就能得到结果。-This is a software that even if the baud rate, powerful, in the MCU communicate without it-yourself basis, as long as the click with this software, you can get results.

基于16f877的单片机人数统计系统源码，可统计进出门的人数，用数码管显示-16f877 microcontroller based on the number of source statistical system can go out into the number of statistics, with digital display

GameCubeMemoryCardTestJig_LastCode_ok,is a SOURCE code for GameCube Memory CARD.

LT-1B开发板例子程序－ADC12_06

凌阳单片机网络系统源码-Sunplus SCM network source

这里只给了TEA5767的控制程序。以下程序中的函数可以直接在主程序中调用