美国TI公司的protel 元器件库，在应用中需要更新，本人收集了最新的版本共30M，为提高上传速度分六次上传。文件名依次为TI_1到TI_6。希望大家设计电路...

24c64子程序，主程序直接调用就可以使用

微型打印机的驱动程序，希望对朋友们有用。-This is a driver of micro printer.Hope it is helpful to friends.

用C51编写的现场总线多机通讯程序，这个程序调试通过，现在应用在微机数据采集系统中。

51读写U盘全套技术资料,原理图,KEIL C51原代码-U disk 51 to read and write a full set of technical information, schematics, KEIL C51 original code

此程序为一排队机呼叫器,主要功能是：用键盘控制液晶显示实现485通讯,具体协议可参考《排队机通讯协议050609.doc》.编译环境为ICC-AVR6.3,采用了ATmega8芯片,晶振速率为6.0000Mhz-Queue for a beeper, the main function is : keyboard control LCD achieve 485 newsletters, reference specific agreement "Queue 050609.doc communication protocol." Build environment for the ICC-AVR6.3 using the ATmega8 chips, crystal rate of 6. 0000Mhz

这是一个mega128单片机通过spi口读写串口flash的程序，已经记过验证-This is a microcontroller through mega128 spi I read and write the serial flash procedures, Verification has demerits

30路遥控开关,按0-30个键分别点亮p0.0-p3.5的灯,32键全灭 可以用此外接驱动后控制30路开关！ 遥控器端口p3.7-30 Road remote control switches, keys, respectively, by 0-30 months p0.0-p3.5 lit the lamp, 32-key body can also take control of 30 after the driver switch! Remote control port p3.7

绝对好用的I2C读写程序-absolute and easy to read and write procedures I2C

freescale单片机串行通讯程序,数据包方式，支持数据发送正常检验,并可使用命令实现对片机FLASH的读、写和擦除功能。-Freescale MCU serial communications, data packets, sends the data to support normal testing and can be used to achieve an order-of-FLASH read, write and erase functions.

philips单片机IAP读的源代码，使用c来调用-philips Singlechip IAP Reading the source code, use c to call