热敏电阻+ ADC0804温度测量精度为0.3摄氏度，我..

控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序.-Control motor movement, G code program, if the G code is not clear, please understand G code, and then look at the procedures.

单片机编程的常用子程序，编程时候简单修改就可以使用。-Microcontroller Programmer common subroutines, programming time can use a simple modification.

单片机用T1中断在IO口P1.0输出乐曲(在P1.0口与VCC间接一喇叭即可听到) 1.由于输出的是方波，比较难听:-)你也可以将波形细分用DA输出正弦波 2.由于T1频繁中断，任何其他中断发生都会是乐曲打顿，只适合试验 3.优化音符编码：一个字节中包含节拍、音符、升降调，可区分数据和命令 -Single-chip microcomputer used in the IO port T1 interrupt output music P1.0 (P1.0 port with VCC in the indirect one can hear the speaker) 1. As the output is a square wave, more bluntly :-) You can also fine-waveform DA output sine wave with sub-2. Due to the frequent interruption of T1, any other interruption occurs Dayton will be playing music, is only suitable for test 3. optimized coding notes: A byte contains rhythms, notes, take-off and landing tune can distinguish between data and command

基于mips CPU，uboot下flash读与LCD显示程序。-Based on the mips CPU, uboot Reading under the flash and LCD display program.

第六期SRTP-基于AT89C52的智能温控仪设计，可以当作课程设计，-The sixth issue of SRTP-based temperature controller AT89C52 intelligent design, can be used as curriculum design,

Keil C 编程的手写板-Keil C Programming 5270

msp430单片机控制小灯键盘程序,这是我搞的很熟的程序-MSP430 single chip microcomputer to control the keyboard lights, this is I do the procedure very well

c8051f330UART,c8051f330串口程序，大家可以试一下，-c8051f330 uart serial

软USB核的电力开关PowerSwitch-soft USB nuclear power switching PowerSwitch

这是一个简单的pid控制程序，用的是增量式pid控制，在智能车上使用的。-This is a simple pid control procedures, using the incremental pid control, used in the smart car.