usb receive main program c

使用68013的测试程序，包含68013固件程序（采用slave FIFO bulk同步读写，EP2 OUT，EP6 IN），驱动，PC端测试用程序。CPLD的VHDL代码-Test procedures for the use of 68,013, including 68,013 firmware (using the synchronous slave FIFO bulk read and write, EP2 OUT, EP6 IN), driver, PC-side test procedures. VHDL code of CPLD

CY7C63743 usb键盘的源码-CY7C63743 USB keyboard FOSS

一些Cypress公司USB2.0固件程序，学习USB2.0开发-Cypress USB firmware procedures, the development of learning USB2.0

u盘复制源代码，目前支持市面上流行的所有元素，希望对大家有帮助-u disk copy source code, available on the market currently supports all the elements of pop, in the hope that everyone has to help

用VC++编写USB接口通信程序用VC++编写USB接口通信程序-With VC++ Prepared with USB interface communication program VC++ Preparation USB Interface Communication Program

一个ucos下的usb程序 包括底层驱动以及一部分应用程序 但是没有ucos的源代码 需要自己添加在souce目录中-USB utility under uCOS, including low layer driver and part of application. No uCOS source code. Need to add it into source dir.

很实用的通用usb驱动程序的应用程序开发指南-Very practical generic usb driver Application Development Guide

PC端的USB主机源代码-USB PC-mainframe source code

This example firmware is based on Microchip s USB Support Firmware. The purpose of this example is to provide a model for making a USB combination device. This mainly entails having the USB descriptors set up correctly. File usb_ch9.c contains the mouse and keyboard descriptors in the correct configuration. The main routine of this example moves the cursor in a circle and sends keyboard keycodes for the message "Microchip USB" over and over again. Some advice: Before running this firmware open a blank text document. Make sure that when you run the device/emulator that you are able to give focus to the document. The cursor will be moving in a circle so make sure you have plenty of room to click on the editor window. This will allow you to see the message "Microchip USB" without inadvertently having the message type over an existing document.-This example firmware is based on Microchip s USB Support Firmware. The purpose of this exampl