录DEC6713的UART串口的测试程序。需要将板上的跳针JP3、JP5各自短接，将UART通道A 和通道B均配置为RS232方式。...

基于DSP的fangbo.asm 利用定时器Timer0在XF脚产生周期1s的的方波 此程序采用100Mhz的时钟频率，产生的方波-DSP-based fangbo.asm use timer Timer0 XF feet produced in a cycle of the square"s procedure using 100 Mhz clock frequency of the square wave

DSP RTOS源代码-DSP RTOS source code

5402 ExInt源程序，都可以用，通过仿真的-5402 ExInt source, can be used, through simulation

本文件的内容是实现TMS320VC5510对指纹芯片FPC1011C读写程序-The contents of this document is to achieve on the fingerprint chip TMS320VC5510 to read and write procedures FPC1011C

DSP28335程度，有源电力滤波器，完成DSP工程文件，包含所有库文件等，main文件中有APF完整程序。下载程序存储在flash中，运行时搬运至ram，加快运算速度。

基于LABVIEW和DSP的液压伺服控制系统设计文档，其中da使用da7625 很有参考价值-LABVIEW-based and DSP-hydraulic servo control system design documents, including the use of da valuable da7625

2812的CAN总线通信程序，适合初学者-2812 s CAN bus communication procedures, suitable for beginners

录DEC6713的UART串口的测试程序。需要将板上的跳针JP3、JP5各自短接，将UART通道A 和通道B均配置为RS232方式。-Recorded in the UART serial DEC6713 test procedures. Need to jump on-board pin of JP3, JP5 their shorted to UART channel A and channel B are configured for RS232 mode.

基于LMS的双向回波削除源码，不过回波幅度不要大于0.2,否则算法认为DOUBLE TALK DETECT。各位可修改此阀值，试试效果-based on the two-way LMS Echo slashing source, but not greater than the rate Echo 0.2, or that the algorithm** DOUBLE TALK. You can modify this threshold, try Effect

详细描述了,由DSP5402控制的ISP1362的初始化,以及设为HC模式的整个工作过程-Described in detail by the DSP5402 control initialization ISP1362, as well as the HC mode is set to the entire work process