基于DSP的fangbo.asm 利用定时器Timer0在XF脚产生周期1s的的方波 此程序采用100Mhz的时钟频率，产生的方波...

低通滤波的5402的dsp程序-low-pass filtering of the 5402 procedures dsp

该程序是基于TMS320LF2407A的单片机，已经过调试。

2812DSP串口使用方法，在RAM中调试，应经通过测试。-2812DSP serial port to use, in the RAM in the debugger, it shall be tested.

Example_2833x_ucosii_run_in_flash_nonBIOS   基于dsp28335的，在flash里运行，已测试

DSP2812下,C调汇编的128点FFT程序,算法为TI提供,定点,测量信号频率和幅度较好,速度比C快三倍左右.-DSP2812 under, C tune compiled 128 points FFT procedures, algorithms for TI to provide, point, measure the signal frequency and amplitude is better, faster than C for about three times faster.

有需要自适应滤波算法的来，希望对大家有帮助-need adaptive filter algorithm, we hope to help

详细介绍了DSP的一些详细算法，包括一些C语言的实现-Described in detail a number of DSP algorithms in detail, including some C language realize

算术运算在我们普通的计算机上很容易实现！但是在我们的DSP上，由于其没有相对应的程序支持，实现就比较麻烦！那么究竟该怎么做呢！就看看吧！-The arithmetic operation is very easy on our ordinary computer to realize! But on ours DSP, because it has not corresponded the procedure support, the realization quite is troublesome! Actually then should how do! Has a look!

这个程序运行在CCstudio平台上，所用语言为c语言，完成的功能是电机pwm死区变换-This program runs in CCStudio platform, the language used for the c language, the completion of the function is to transform motor pwm dead zone

tms2407的一个评估版的sci发送测试小程序-tms2407 an assessment of the sci Send a test version of the applet