单片机与时钟芯片DS1302接口程序，C语言代码，简单易用。

IO型单片机使用手册-IO-SCM Manuals

利用单片机控制实现的计算器，用lcd显示计算的过程和结果。-SCM control to achieve use of calculator, lcd display with the calculation process and results.

控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序.-Control motor movement, G code program, if the G code is not clear, please understand G code, and then look at the procedures.

串口模拟程序,只占用一个T2资源-serial simulation program, occupying only a T2 resources

24c04读写程序，同时控制p10口的打开和关闭-24c04 read and write procedures for control of p10 at the same time the mouth opened and closed

这是一个基于凌阳单片机SPCE061A的GPS定位仪c代码-This is a single-chip based on the Sunplus SPCE061A of GPS positioning c code

用串口实现单片机和带键盘的显示屏之间的通信，包含包头包尾。-By serial single-chip implementation of the display and keyboard with communication between the packet contains the end of Baotou.

DS1820v2.c simple 1wire example-DS1820v2.c simple 1wire example

在C51单片机上使用的1602LCD驱动程序，-In the C51 microcontroller used 1602LCD driver,

这是一个keil c51 程序 采用8031单片机，是一个学习keil c 的入门级程序-This a procedure used Keil decoder 8031 is a study Keil c entry-level procedures