a small embedded operating system kernel can be used for a variety of hardware p...

ISP for STR73X 默认情况下, bank0 是映射到地址0x00. 考虑到,IAP程序需存储在bank1,而用户程序需存储在bank0. 因此须使用CAPS工具,将bank1映射到地址0x00. 另外, 在IAP程序运行期间,必须在执行用户程序跳转之前,通过程序将bank0重映射到地址0x00(注:IAP程序已经实现了bank0重映射到地址0x00,用户不需要自己来编写代码).-ISP for STR73X default, bank0 is mapped to address 0x00. Taking into account, IAP process is stored in the bank1, while the user program to be stored in bank0. It is necessary to use the CAPS tool bank1 mapped to address 0x00. In addition, IAP procedure during operation must be in the implementation of user program before Jump through the procedure will bank0 re-mapped to address 0x00 (Note: IAP program has achieved bank0 re-mapped to address 0x00, the user does not need to write their own code).

Verilog实现的I2C协议，直接在ISE下打开就可以-Verilog implementation I2C protocol to open directly in the ISE can be

蓝牙耳机软件源代码

PCI总线仲裁参考设计Verilog代码-PCI bus arbitration reference design Verilog code

关于嵌入式开发的状态机思路，使软件编程效率更高-With regard to the state machine embedded development ideas, to make more efficient software programming

这是R、C、L的全国电子设计，从07-2009-This is the R, C, L of the national electronic design, from 07-2009

USB 源码 ISP1581 Device controller--ISP1581 Device controller.

舵机控制程序，舵机的控制信号为周期是20ms的PWM信号，其中高电平持续时间0.5到2.5ms。-steering control procedure, the servo control signal is 20ms cycle of the PWM signal. margin which lasted 0.5 to 2.5ms.

DSP28335驱动SD卡的例子，采用c代码编写，有注释，测试通过，供需要的同学参考~

本页将帮助您配置PIC定时器2和PWM模块，您还将获得一个随时可用的C源代码