at91sam7s64的论文，at91sam7s64的论文，

12,14,16点阵汉字显示文件 12,14,16点阵汉字显示文件-12,14,16 dot matrix display Chinese characters files characters dot matrix display documents 12,14,16

51单片机串口调试程序，谢谢大家使用，本人刚出道，希望大家多多包涵-51 microcontroller serial debugging procedures, thank you all use, the title track, I hope you will forgive me

串口数据转换,VB60源程序,本人从网上收集，分享给大家，谢谢，没有解压密码.-Serial data conversion, VB60 source, I gather from the Internet, to share to you, thank you, there is no decompression password.

测量温度上下位编程代码，测试绝对好用，欢迎学习使用，请勿用于商业用途。-vbrs232 c avr

WL013开发板，串口通信详细例程，含软件流程框图，c源程序、asm源程序等!适合初学者学习！-WL013 development board, serial communication detailed routines, including software flow chart, c source. asm2 source, etc.! for beginners learning!

这是本人所编的串口传数据的程序，经测试能用，希望大家给于指导-This is my series of mass serial data procedures, have been tested can be, I hope to everyone in the guidance

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

f2812串口通信接口B口，c语言,中断-f2812 serial communication interface B port, c language, interruption of

dos下用TC2.0编译的几个串口例程-a few examples in TC2.0 and Dos

这是一个串口监视程序，能够很好的调试串口并监视串口数据。-This is a serial surveillance procedures to good serial debugging and monitoring serial data.