基于AVR单片机mega8的电表c源程序（第四部分，红外收、发过流判断及其他）...

61单片机模拟8080总线时序的程序，很多接口芯片的时序就是这个-61 Microcontroller Bus Timing simulation of 8080 programs, many interface chip timing is this

用于参考msp430f149硬件连接图，个个引脚的分配，可以做下载-MSP430F149 for reference hardware connection diagram, the distribution of each pin, you can download to do

一个用单片机控制TC35I发短信的例子，同时可以将接收到的UNICODE码转换为HZK16,对初次开发短信的网友会有帮助-TC35i used to control a single-chip message-fat example, at the same time can be received is converted to UNICODE code HZK16, the initial development of the message users will be helpful

lpc单片机内部看门狗计时器程序-lpc SCM internal watchdog timer procedures

24C01A的读写程序,有须要的朋友可以拿去用用.-24C01A process of reading and writing, it is necessary to be taken by friends to use.

点亮键盘灯,-Lit keyboard lights,

温度控制器V1.5 显示为三个共阳极LED 温度传感器用单总线DS18B20 CPU为2051，四个按键，分别为UP，DOWN，SET 温度调节上限为125度，下限为-55度 只能用于单只18B20-Temperature Controller V1.5 show for a total of three LED anode temperature sensor with single CPU for the bus DS18B20 2051, four keys, respectively UP, DOWN, SET temperature regulator ceiling of 125 degrees and lower limits of-55 degrees can only be used solely 18B20

用8051单片机控制的基于DS18B20的温度上下限控制报警的KEILC工程文件-By 8051 the control of the temperature of upper and lower limits based on DS18B20 control alarm KEILC project file

实现一个基于8051单片机控制的4相步进电机系统 ，由单片机产生正确的驱动脉冲信号。-8051 based on the realization of a controlled 4-phase stepper motor systems, from single-chip driver generate the correct pulse signal.

51单片机矩阵键盘的设计与调试，建议使用52单片机。-51 Single-chip design of the keyboard matrix and debugging, it is recommended to use single-chip microcomputer 52.