实现I2C终线的功能，24C64的I2C的总工会系啊

51单片机调试用程序-debugging MCU with 51 procedures

msp430f449的文件 很有用的-MSP430F449 useful documents

凌阳61 的1602液晶显示程序 引用头文件就行-61, 1602 Sunplus LCD procedures quoted header file on the line

Micro codes for interfacing with atmega16

这个程序是控制2401模块一直发送字节，和上一次的可以配合使用，实现发射接收并且上传到电脑串口-This procedure is to control module has been sent 2401-byte, and the last can be used in conjunction to achieve the launch reception and uploaded to the computer serial port

在网络中,有时候会想检查自己电脑的端口的状态,这是端口扫描器的C语言源代码, -err

利用51单片机实现sle4442的读写，可以使用-51 Singlechip sle4442 realize the use of reading and writing, you can use

24LC256的C51驱动程序, 采用8052系列单片机-24LC256 C51 driver

SE-Candence SOC Encounter工具使用设计流程，源于一项项目-SE-Candence SOC Encounter tool design process, from a project

C8051F120初始化SPI，启动CC2420。通过将CC2420 得VREG_EN 引脚置位高电平使能Voltage regulator，等待其稳定；然后重新启动CC2420 芯片，等待晶振起振。-Initialize SPI, start the CC2420. By CC2420 have VREG_EN pin high to enable the set Voltage regulator, waiting for their stability and then re-start the CC2420 chip, since waiting for crystal oscillator.