这个是我写的以t6963为主控芯片的显示屏的程序，能控制所有以t6963为主控的屏...

这是f040与2401连接后，进行通信的程序。已经调试通过了 仅供大家参考 第一次传 不好的习惯请大家指正 -This is connected with the 2401, the communications procedures. Debugging has been adopted only refer to the first-bad habit of correcting Thank you, please

一些收集到的PIC文章，相信对PIC编程员有一定的帮助-collect some of the PIC article, I believe the PIC programmers can help

英飞凌C167的32位循环冗余校验码产生例子。-infineon C167 CRC32

单片机实现直流数控稳压电源,可调电压为0-9.9伏,步进为0.1伏,可以自动扫描键盘以增加或者减少电压-MCU NC Regulators DC power supply with adjustable voltage of 0-9.9 volts, stepping to 0.1 volts, can automatically scan the keyboard to increase or reduce the voltage

Cs8900网卡DSP驱动 -Cs8900网卡DSP驱动Cs8900网卡DSP驱动

CS5532的驱动程序，基于AT89S52,调试通过-CS5532 driver, based on AT89S52, debugging through

这是一个智能小车的原理图，里面包括红外传感器的收发，液晶显示模块，方波产生模块，单片机控制模块等．-This is a smart diagram of the car, including infrared sensors inside the transceiver, LCD modules, square wave generated modules, SCM control module.

串口发送程序。运用51单片机。采用汇编语言，程序简单，-Send serial procedures. The use of single-chip microcomputer 51. Using assembly language, the program is simple,

功能： 1、作为下位机采集8255数据并将此数据通过通讯送出，传输十路 2、采集数据为BCD，不处理后 3、通讯采用方式一-Features: 1, as under the 8255-bit machine data collection and data communications sent through the transmission path 2, 10, collecting data for the BCD, not after 3, means of communication using a

w77e58单片机的双串口 的操作，寄存器的设置和 串口读写等-w77e58 SCM dual serial operation, the setup and register read and write, etc. Serial