HD7279与51的驱动，主要修正了延时函数及按键函数，按键采集通过中断采集。...

用KEIL开发的操作C51单片机的IO口，使得完成对IO口的读写等操作-KEIL development operation with C51 MCU IO mouth, making completion of the IO port to read and write operations, etc.

用于对TLC5615数模转换芯片进行控制，把接收到的数字信息，送到5615从而恢复模拟信号！-for several TLC5615 right-analog converter control, and receive digital information, which was sent to 5615 so as to restore analog signal!

51单片接在LCD1602汉字显示的c语言写的驱动程序。-51 single-chip access in the LCD1602 display Chinese characters written in c language driver.

高精度实时时钟－SD2001驱动程序 用于威帆电子SD200X系列IC驱动-high-precision real-time clock-driven procedures for SD2001 Granville sails electronic SD200X Series Driver IC

12232的一个显示汉字的C语言程序，希望给有需要的人。-A display of 12,232 Chinese characters C language program and hope to those in need.

基于ＳＴＭ上的122x32液晶显示程序显示图形及汉字，已经通过验证-Based on the STM on the 122x32 graphic LCD display and the Chinese characters, has passed validation

这是点阵程序 个人认为先学点阵再学lcd比较好 p0 p2分别接16*16点阵的高八位和低八位(纵向取模) p3口低四位接4-16线译码器（74ls154）译码器低电平为列选 消除鬼影的方法：-This is the program individual lattice lattice before you think lcd is better to learn p0 p2, respectively, then 16* 16 lattice of high and low 8 8 (vertical modulus) p3 I received a low four 4-16 Line Decoder browser (74ls154) low-level decoder for the elimination of ghosting out the election approaches:

基于FREESCALE单片机9S08DZ60的LIN从节点的应用层源代码.LIN是通过UART串口来实现的.开发环境为CODEWARRIOR FOR HC08-Based on Freescale

12864 在51单片机中的程序，用点阵模块改个数组就可以变成自己的了-12864 in MCS-51 in the program, with a change of lattice modules can be turned into its own array of

比较时钟的另类应用---模拟发送红外遥控的波形 比较时钟一般用来作一个固定的定时器，做系统时钟或固定的时钟任务，-Comparison of the alternative application of the clock to send the infrared remote control--- Simulation waveforms generally used for clock compared to a fixed timer, so the system clock or the clock fixed tasks,