timer application programming examples for understanding the function of the tim...

用SmartGen生成一个256*8的大小同步FIFO，并通过串口发送数据初始化FIFO。然后，再通过串口返回到上位机的串口调试程序显示，确认数据是否正确。-SmartGen generated with a size of 256* 8 Synchronous FIFO, and sending data through the serial port to initialize FIFO. And then back through the serial port to the PC serial port debugger display to confirm the data is correct.

C8051F040 ＣＡＮ总线编程，演示时需两块０４０的开发板，开发板的按键状态通过CAN总线发到另一个开发板上并通过ＬＥＤ显示出按键状态．-C8051F040 CAN bus programming, presentation 2 040 when the development board, development board through the state of the keys issued to another CAN bus and through the development of on-board LED shows the status button.

easyarm1138用c语言开发的液晶lcd12864串行口显示-easyarm1138 c lcd12864 chuanxing

一个很好的例程，希望对您有帮助，欢迎探讨

采用实时芯片DS1302来计时,并用LCM液晶显示!有较高的精确度!-Real-time chip DS1302 to time, and LCD LCM! Have higher accuracy!

该文件是采用通用IO口模拟I2C存储器通讯的,24LC256是低电压I2CEEPROM.-this document is to adopt a common IO memory simulation I2C communications, 24LC256 is low voltage I2CEEPROM.

基于时间触发调度器的直流电机闭环控制 -Time-triggered scheduler based on the DC motor closed-loop control

自己写的lcd1602的驱动程序，底层驱动和上层程序层次分明，很容易移植-?????#39 的lcd1602的驱 ???绦??????闱????蜕????绦???39 ?置 ????苋菀 ?移?

FIQ有FIQ_PWM、FIQ_TMA和FIQ_TMB三个中断源,当定时器A或B计满溢出时产生中断请求信号TA_TIMEOUT_INT或TA_TIMEOUT_INT,CPU响应后进入中断执行相应的子程序控制二极管发光。A口的低四位接LED灯，B口的低四位接LED灯.-FIQ has FIQ_PWM, FIQ_TMA and FIQ_TMB three interrupt sources, when the timer A or B when the expiration overflow interrupt request signal TA_TIMEOUT_INT or TA_TIMEOUT_INT, CPU response after interruption of the implementation of the corresponding subprogram control light-emitting diodes. A low population of four LED lights then, B I take the low four LED lights.

93C46/66的读写程序，编译环境Uvision2，4线SPI接口的EEprom芯片的读写-93C46/66 literacy program, compile environment Uvision2, 4-wire SPI interface EEprom chip reader