Robot vehicle control, MCU, photoelectric sensor

一个针对320240液晶的ZLG/GUI移植，没有使用液晶控制器，利用LPC2103端口直接控制，屏幕会稍有闪烁-A target of 320,240 LCD ZLG/GUI transplantation, did not use the LCD controller, using LPC2103 port direct control, the screen will flicker a little

32位arm9微处理器S3C2410的中断程序测试源代码-32-bit ARM9 microprocessor S3C2410 interruption procedures to test the source code

、新华龙C8051f340的中文开发资料、-, The new Chinese C8051f340 hualong development information,

八路电压表C程序 使用AT89C52单片机，12MHZ晶振，P0口读入AD值，P2口作AD控制，用共阳LED数码管 P1口输出段码，P3口扫描，最高位指示通道（0-7）。-Eight-way voltage meter C program using AT89C52 single-chip, 12MHZ crystal, P0 I read into the AD value, P2 I make AD control, with a total of P1 Yang LED digital tube output above code, P3 port scan, the maximum channel bit instructions (0-7).

NTC电阻.pdf NTC电阻.pdf-NTC resistor. Pdf NTC resistor. Pdf

本程序已经调试通过，使用I2C来从外部时钟芯片中读取并写入时间。文档包含i2c的驱动程序、时钟芯片的读与写、以及使用定时器中断产生脉冲来模拟gps对时。-This procedure has been debugging through the use of I2C chip from the external clock time to read and write. Document contains the i2c driver, the clock read and write chip, and the use of the timer interrupt to simulate the pulse generated when the gps on.

FAT16文件系统原理，较详细的说明文件，很好的资料-FAT16 file system principle, more detailed documentation, very good information

ch451键盘LED管理芯片的驱动程序,很好用的,设计很标准的代码-ch451 keyboard LED chip management of the driver, the good design is the standard code

两相四线步进电机驱动,控制程序.C语言编写-Two-phase four-wire stepper motor driver and control program. C language

PWM应用程序编写方法实例，对于初学者较为使用-PWM application example of the preparation method, for beginners to use more