文中作者通过理论仿真详细分析了OFDM系统中子载波间干扰ICI对系统性能的影响...

vc++ 6.0 二进制文件操作类,大家参考-good

Modbus 源码程序 非常详尽 适合初学者-Modbus-source program suitable for beginners, very detailed

汽车ECU诊断协议j1979是比较重要的协议之一，开发通讯协议工程师可参考-Auto ECU diagnosis j1979 agreement is one of the more important agreements, the development of communication protocol may refer to Engineer

USB总线接口芯片CH375的介绍，对于进行USB开发的人都很大的指导作用。-USB bus interface chip CH375 introduction to USB development for people a lot of the guiding role.

接收机,利用C8051F330编写的接收解码程序-receivers use C8051F330 prepared to receive the decoding process.

本软件具有简洁的风格，易用的界面，方便您输入查找好友的通讯资料，而且是完全免费！强烈推荐！-software with the simplicity of style, easy-to-use interface to facilitate the importation of your friends find the communications, but is completely free! Strongly recommended!

DSP ti6416芯片的使用方法，怎么优化代码等方法-DSP ti6416 chip to use, how to optimize code, etc.

这是一个定点的多带OFDM物理层发射机/接收机模型,共122个子载波，22个导频，采用QPSK调制,5/8前向纠错码(删余卷积码.)-This is a sentinel of the multi-band OFDM physical layer transmitter/receiver model, a total of 122 sub-carrier. 22 pilots, using QPSK modulation, 5/8 prior to the error-correcting code (I delete convolutional codes.)

两块 WeBee 模块通信，一个模块作发射，另外一个模块接收，发射模块依次按下按键 S1，改变接收模块 LED1  的亮灭的状态。实现无线点灯功能。例程的源代码 CC2530 BasicRF.rar 是 TI 官网上下载的，用户可以去 TI 官网 注册并下载。首先说明，TI 官网的程序的开发平台是 TI 官网的开发板，硬件资料有所不同，所以要在 WeBee  板上实现无线点灯功能，必须对其代码稍作修改。

本程序仿真了CDMA系统在理想功率控制条件下的上行链路小区容量-This procedure simulated CDMA system in the ideal power control under the conditions of the uplink cell capacity