这时最简单的一个程序，运行后，三个LED在闪，因为程序没有初始化串口，所以运行后超级终端没有反应...

Coldfire MCF5282 DBug bootloader

使用0.18um 标准 CMOS 的工艺设计，内嵌ASIX CORE（32 位RISC 内核，兼容ARM720T，带8KB 指令数 据Cache 和全功能MMU），采用冯诺依曼结构-Using 0.18um standard CMOS process design, embedded ASIX CORE (32 bit RISC core, compatible with ARM720T, with 8KB Data Cache directives and full-featured MMU), the use of the structure of von Neumann

使用C51做的电子钟，刚出炉的哟，谢谢大家-C51 make use of the electronic bell, fresh yo, thank you everyone

uCOS移植范例,开发人员或嵌入式爱好者可以借鉴。-uCOS transplantation example, developers or embedded lovers can learn from.

ARM7―LPC2124―串口开发实例 基于Keil uVision3源码开发再进行Proteus 7 联合对ARM7―LPC2124―I2C硬件电路仿真-ARM7-LPC2124-developed examples of serial Keil uVision3 source development based on further joint Proteus 7 on ARM7-LPC2124-I2C hardware circuit simulation

该工程是一个基于嵌入式s3c2410的一个led测试代码-The project is based on an embedded s3c2410 led by a test code

arm_7x256的ADS1.2的网络测试程序-arm_7x256 the ADS1.2 network test procedures

如何在基于NFS的开发环境下开发ARMSYS的44B0开发板

HCS08例程：本程序是TIMER模模块的例程，所用资源为单片机模定时器MTIM，所接器件为LED灯，其中D2与PTA0，D3与PTA1相连接！-HCS08 routines: This procedure is routine TIMER mode module, the resources used for the single-chip mode timer MTIM, the access device for the LED lights, which D2 and PTA0, D3 and PTA1 connected!