PIC18 and LCD12864 the C language program, pay attention to pin modification.

在C8051F930单片机上，利用端口匹配和PCA实现按键的长按、短按功能。-In the C8051F930 microcontroller, using the port matching and PCA to achieve a long button press, short press functions.

MEGA16 串口收发数据，采用中断方式，给大家一个参考-MEGA16 serial send and receive data, using interrupt mode, give you a reference

USB开发D12的结构-USB D12 structure

PIC单片机 液晶 组成的万年历，带有protues仿真-PIC, composed of single-chip LCD calendar with protues Simulation

拷拷贝到你的Keil安装目录下的c51in文件夹中。 工程文件中需设置一下: project->Option for Target Target1 选Debug页 左侧最下面 Dialog Dll 一般是DP51.DLL，不用修改 Parameter 中是 -P51 在其后加入 -dledkey 即该行看起来应该是这样的： -p51 -dledkey 保存即可 进入调试后，点击：Peripherals，其中多出一个“键盘LED实验仿真板”选择该项即可。-emboss your copy of the Keil installation directory under the decoder bin folder. The project document to be provided as follows : project-gt; Option for Target Target1 election Debug bottom of the left page is generally Dialog Dll DP51.DLL, need not be amended Parameter is- P51 add after-dledkey that the bank should look like this :-p51-can be preserved into dledkey to debug and click : Peripherals, in which more than a "keyboard LED simulation board," which can be chosen.

用LPC93251操作nand flash K9F6408，能正确擦，写，读。改用其它芯片，方法类似，注意时序就行了。如换用大容量flash，请注意每块的页数，6408每块是16页的。-with LPC93251 operation nand flash K9F6408 can correct rub, writing and reading. Other chip switch, a similar manner, the attention on the timing of the trip. If used for large-capacity flash, to every piece of pages, 6,408 each block is the 16.

CRC16，C语言运算源码，包括四种算法，直接计算法，半查表法，全查表法，双8位表全查表法，适用于工业控制领域校验通讯数据使用，和MODBUS数据校验，在对不同的系统资源的要求环境下，采用不同的算法-CYXLIC REDUNDANCY, C language source computing, including four algorithms, direct calculation method, semi-look-up table method, the whole look-up table method, dual eight-wide table look-up table method, applied to the field of industrial control the use of calibration data communications and MODBUS calibration data in different systems of the requirements of environmental resources, mining different algorithms

关于51单片机控制595驱动的数码管程序，编译过，可直接使用，有HEX文件-51 single-chip 595 on control-driven digital control procedures, the compiler, and can be used directly, there are HEX file

非常好用的CH375串口转USB口程序.可以方便的实现,用USB通讯,和做为主机- code usb

一个用C51驱动PT6324+VFD的源程序，绝对可执行