STM32是以Cortex

2812的tcpip程序C语言的，应该有用的！-2812 of the C language tcpip process, it should be useful!

ARM cortex-M3系列处理器的代码，包括通用输入输出GPIO、模数比较器ADC、模拟比较器COMP。（IAR环境工程）-ARM cortex-M3 family of processors code, including general-purpose input-output GPIO, modulus comparator ADC, analog comparator COMP. (IAR Environmental Engineering)

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

日本北斗电子系统TCP/IP以太网机设计

基于linux环境的arm板开发，这是可以进行实验的原文件-linux-based environmental arm plate development, which should be able to conduct experiments in the original document

ARM 嵌入式系统 LPC22xx UART1实验代码-ARM Embedded System LPC22xx UART1 experimental code

这是ARM处理器S3C2410对实时时钟编程的原代码-This is the ARM processor S3C2410 on real-time clock programming source code

应用背景stm32低功耗待机和唤醒，实现低功耗和外部中断唤醒。关键技术我们最终要实现这样一个功能：通过长按（ 3秒） WK_UP按键开机，并且通过DS0DS0DS0的闪烁指示程序已经开始运行， 再次长按该键则进入待机模式的闪烁指示程序已经开始运行。再按一次进入睡眠模式。

MEGA16的TWI总线的应用，具体是读写可变电阻AD5161-MEGA16 wirte OR read AD5161

MATLAB程序，用于dsp编程软件仿真，信号的产生，fft变换-MATLABghdsp