This is a single

这是一个基于89C51单片机的简易信号发生器的源程序，程序代码由C语言编写-This is an 89C51 microcontroller based on the simplicity of the source signal generator, code written in C

定时器中断实验代码， 定时器3进行0.1秒定时，每0.5秒改变一次P2,P3口的值以产生走马灯效果。-timer interruption experimental code, three timers for 0.1 seconds regularly, every 0.5 seconds to change a P2, P3 to the values I have merry-go-round effect.

LT_1B msp430开发板例子程序－TB9

KEIL51的一元二次方程的程序-KEIL51 a square procedure

AD采样实验，结果通过串口送PC显示 结果送内部数据区30H，共16个-AD conversion

图形液晶TG12864B-2驱动程序-Graphic LCD Driver TG12864B-2

单片机 时钟程序,包含秒表，闹钟，时间三个功能-MCU clock.c

X5045芯片的C51程序，X5045是看门狗加EEPROM-X5045 chip C51 procedures X5045 is the watchdog increase EEPROM

由C 语言实现的tl549 利用的是KEIL环境已经得到验证-Achieved by the C language using tl549 is KEIL environment has been tested

本程序是AD MAX197驱动程序。精度高。-This procedure is AD MAX197 driver. High accuracy.