DS1302ANDSP2，详细介绍DS1302及PS2的源代码

这是开发ARM LPC2000系列的资料-this is the development of ARM LPC2000 series of information

AT91RM9200控制SDRAM的程序ic42s324-AT91RM9200 procedures SDRAM control ic42s324

AVR试验板程序,有LED,键盘和串口的程序-AVR test board procedures have LED, keyboard and serial procedures

1.单机自发自收串行通信。接收键入字符，从8251A的发送端发送，与同一个8251A的接收端接收，然后在屏幕上显示出来。 2.双机串行通信，在一台PC机键入字符，从8251A的发送端发送给另一台PC机，另一台PC机的 8251A的接收端接收，然后在屏幕上显示出来。 -1. Since the resumption of spontaneous stand-alone serial communication. Type the characters receive from the sending end to send the 8251A, 8251A with the receiving end of a receiver, and then displayed on the screen. 2. Dual serial communication, in a PC-type characters, from the sending end 8251A sent to another PC, another PC-8251A to receive the receiving end, and then displayed on the screen.

y uurug bdf lgdfjg dfg df g dt-y uurug bdf lgdfjg dfg df g dt

华恒的2410核心板原理图，用户只要按照图上的话，肯定没有问题-huaheng core of the 2410 board schematics, as long as users of the Plan, will have no problem

这个是基于通过单片机AD采集模拟信号，我用的是自己做得的一个心电采集电路，然后在STM3 2 单片机上通过LCD显示出来                                                                                                                 

资源描述本代码基于c8051f410单片机为硬件核心，通过对芯片内部资源adc,uart0,timer等的有效配置和利用，完成一个简易的电压测量，并讲测得的电压值通过上位机的通信功能传送至上位机。

用LPC213X系列的PWM来产生语音。语音数据来源于PC机转换后得到的。最大可以是16位的。 由于是PWM所以输出端口需要低通滤波才能够得到比较干净的声音。 可以经过修改使用LPC2132以上的ARM的D/A来产生。 This project outputs audio on PWM0 using wave samples that are stored in the on-chip Flash ROM. -LPC213X series used to generate the PWM voice. Voice data from the PC after the conversion. It is the largest of 16. Because there is PWM output ports need low-pass filter can be relatively clean voice. It has been modified over the use LPC2132 ARM D/A to produce. This project outputs audio on PWM0 using wave samples that are stored in the on-chip Flash ROM.

刚调试好的TI公司的ADS7818程序，在430的板子上已通过检测-Just a good debugging TI