LPC23XX, 485 communications, can be directly used

CSerialPort类最新源码V1.27-V1.27 up-to-date source CSerialPort category

Port Reader RS232, 485

要完成串口通信, 在32位模式下, 一般说来有以下四种方法-to complete the serial communications, in 32-bit mode, in general the following four methods :

USART的驱动程序，在C++编译环境下，进攻学习参考-USART the driver, in the C compiler environment, learning offensive reference

实现两台机器之间的串口通信！可以对串口进行调试！-achieved between the two machines serial communications! Can serial debugging!

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

用C++写的RS232串口异步通讯功能模块，支持16550 UART芯片，中断收发数据，波特率最大115200bps，自定义收发数据缓冲大小，支持软硬件流控。-C wrote asynchronous RS232 serial communication module, 16550 UART chip, Transceivers interruption data, 115,200 bps maximum baud rate, since the definition of sending and receiving data buffer size, support hardware and software flow control.

使用vb.net实现串口通讯的过程，具体见程序。谢谢！-vb.net using Serial communication process, see the specific procedures. Thank you!

RS232串口函数包，包函大多数的串口调用的函数-RS232 serial port function packages 9.1.2 Most of the Serial calling function

一段ADSP21262用DAI口实现UART通讯的汇编源代码。