大数加法

用stm32单片机制作一个时间显示界面可以触摸设置时间(Stm32 microcontroller produced by a set time period can touch display interface)

说明：  mips 固件，开发源文件，用于逆向开发，逆向二进制符号执行(MIPS firmware, developing source files for reverse development, reverse binary symbol execution)

绝对的好东西dfdfdfdfdfafasfsdfsfdfsfasfdsfafdsfsdfsfsdf

使用VC++2013+OSG3.3.1编写的视频纹理程序，osg视频纹理需要下载并编译额外的ffmpeg插件，已经和程序一起打包，可以直接在Windows7或Windows8下直接运行。如果有编译环境，配置好环境变量后就可以直接编译运行

Bacom use mmc not test very fast

硬件资源: 1,DS0(连接在PA8)，DS1(连接在PD2上) 2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面) 3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏) 4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP) 实验现象: 通过按键KEY_UP可以控制定时器AutoReloadTimer_Handle的开启，这个是 周期定时器，一旦开启就会不断的运行，直到按下KEY1将其关闭。按下KEY0 可以打开定时器OneShotTimer_Handle，这是个单次定时器，只会运行一次， 运行周期到了以后就会停止运行，除非按下按键KEY0将其再次开启。(Hardware resources: 1, DS0 (connected to PA8), DS1 (connected to PD2) 2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340) 3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen) 4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP) Experimental phenomena: The timer AutoReloadTimer_Handle can be turned on by keying KEY_UP. This is The periodic timer will run continuously once it is turned on until KEY1 is pressed to turn it off. Press KEY0 You can turn on the timer OneShotTimer_Handle, which is a single timer and only runs once. The run cycle will stop after that unless KEY0 is pressed to turn it on again.)

cocos2d for iphone 教程(cocos2d for iphone )

说明：  端口扫描小程序，C语言编写，亲测可用欢迎使用。(Port scanning program, written in C language, pro-test can be welcomed.)

本文介绍了一个简单实用的个人通讯录管理系统java工程，详细描述了本人在编程时候的编程思想和在MyEclipse 6.5中调试运行的步骤，简明扼要地介绍了整个工程的功能和实用方法。这个个人通讯录管理系统含有添加、删除、查找等基本功能，同时也添加了一些有趣的小功能——支持背景图片的更换。在程序中完成了与数据库的通信，并同样可以对数据库进行添加、查找、删除等功能

sdk的说明文档以及接入流程demo，欢迎下载阅读，