基于Small RTOS51的数据采集器设计

单片机与PC机串口程序，pc机用串口调试工具发送16进制数据到单片机，单片机再返回一个接受到的信号回pc机，-SCM and PC serial port procedures, PCs with serial debugging tools to send 16-band data to a single chip, the microcontroller return to a finer signal to PCs,

PROFIBUS SLAVE PROGRAMS PRO FIBUS SLAVE PROGRAMS

用L298作为驱动器，控制两相混合式步进电机。 按键从上至下分别为减速，加速，正转，反转，停止。 具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。 转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

飞思卡尔12的定时器功能，能实现周期的定时，12定时器的基本功能-Freescale 12 timer function, can achieve cycle time, the basic functions of the timer 12

C8051F52xA_53xA型单片机的串口驱动源码-C8051F52xA_53xA-based single-chip serial driver source code

本程序用于接收一般的红外线代码。很适合51单片机的新手学习。-This procedure is used to receive infrared codes in general. Very suitable for the novice to learn microcontroller 51.

用L293步进电机驱动芯片做的步进电机驱动器.-Stepper motor driver using L293 chip to do the stepper motor drive.

msp430x22x4的c程序，例子很多，几乎涵盖了msp430x22x4系列的全部功能。-msp430x22x4 c-program, many examples, covering almost msp430x22x4 series of full functionality.

采用ATMEGA8的芯片,功能为智能家居的门禁控制,单相交流电机的控制系统,性能稳定.-ATMEGA8 using the chip, the functions of the Intelligent home access control, single-phase AC motor control system, stable performance.

LPC900波特率的演示程序-LPC900 The Demonstration Program