OCX测试代码

本文件是C8051F040键盘及DA输出测试程序；DA输出端子(J10)可输出2路DA(DAC0,DAC1),四路按键(KEY1--KEY4，须设置跳线JP5)，测试时按下KEY1--KEY4，分别对应DAC0，DAC1输出0.5V，1V，1.5V，2V。 (The present document is a C8051F040 keyboard and DA output test procedures DA output terminal (J10) can output 2-way DA (DAC0, DAC1), four buttons (KEY1- KEY4, shall be provided jumpers JP5), test press KEY1--KEY4, corresponding to DAC0, DAC1 output 0.5V, 1V, 1.5V, 2V.)

这是一个博士编写的关于RBF插值的三维重建的源程序，有需求的人赶紧下！(This is a prepared by Dr. RBF interpolation on the three-dimensional reconstruction of the source, there is a demand for people who hastened to the next!)

用C代码编写通用的Delta并联机器人的运动学正逆解

单片机MC9S08AW60脉宽调制 TPM1CH3 LS2亮度控制 KBI SEG控制亮度等级 。本工程为定时器输出PWM波测试工程实例通过对PWM占空比的调节,实现小灯的渐亮的功能,当占空比为100％时再从0％逐渐增加.PWM的周期一定要足够的快,否则其输出电压的波动范围很大,且测不出一个稳定的电压值,这样通过就观察不到小灯渐亮效果. 另外,在改变PWM的周期和占空比之前和之后要分别禁止和使用。(MC9S08AW60 pulse width modulation TPM1CH3 LS2 brightness control KBI SEG brightness level. This project is an example of testing the output PWM wave of the timer. By adjusting the duty ratio of the PWM, the function of the small lamp gradually brightening is realized. When the duty ratio is 100%, the period of the small lamp gradually increases from 0%. The period of the PWM must be fast enough. Otherwise, the fluctuation range of the output voltage is large and a stable voltage value can not be measured, so the effect of the gradual brightening of the small lamp can not be observed. In addition, the period of the PWM is changed. Before and after duty cycle should be prohibited and used separately.)

Program to carry out insertion sort in C

16X16显示，比8X8显示大一点，可显示任何汉字，8X8显示不行。16的就完全可以。(16X16 display han zi.)

stm32f407读取陀螺仪JY901数据(Stm32f407 reads gyro JY901 data)

STM32 串口读取传感器数据并保存(STM32 serial port read sensor data and save)

c# Hook 全局键盘 鼠标 禁用键盘鼠标-c# Hook keybroad ,mouse

利用C-C++语言编程，实现电子钟的整点报时（从离整点的前9秒开始），并伴随音乐声(The use of C-C++ language programming, electronic bell the whole point of time (from the point from the whole nine seconds before the start), and accompanied by music)