Single

串口通信的单片机程序51单片机串口调试程序一例-Microcontroller serial communication program 51 MCU serial debugger one cases

三个键盘扫描程序，一个为C编写，另两为汇编，共同学习，一起进步！-Three keyboard scanning procedures, the preparation of a C, and the other two for the compilation, together with progress!

用basic编写的t6963c控制器的液晶驱动程序。-t6963c display driver in basic.

串口转发IIC程序，用MEGA16实现，调试IIC接口时非常有用。-IIC serial transponder procedures used MEGA16 realized, IIC debugging interface will be very useful.

急救车与交通灯）（1）南北与东西方向，每个方面由红黄绿三个灯控制（2）南北向：　红（30秒），黄（5秒），绿（25秒）　　　东西向： 红（35秒），黄（5秒），绿（25秒）　　　上述基本参数可以根据实际情况自行调整，灯的变化规律与实际路口规律相同，绿灯在最后5秒钟时，黄灯亮，然后红灯亮，不允许两个方面同时亮绿灯。（3）绿灯的时间显示在数码管上进行显示。（4）可以通过一个开关控制，当开关信号为0时，整个交通灯全灭提高要求：（1）设计一个紧急控制开关信号，当紧急开关信号为1时，两个方向的灯全为红灯。紧急开关撤消后，按照开关按下之前的状态继续运行（其参数要保存）。（2）设计一个夜间行车开关，当开关按下后，两个方向都只有黄灯闪烁，其它灯熄灭。（3）设计两个方向的亮时时间可调。-emergency vehicles and traffic lights) (1) North and South and east-west direction, each with three yellow-green from red lights control (2) to the north and south : red (30 seconds), yellow (5 seconds), Green (25 seconds) to things : red (35 seconds), yellow (5 seconds) Green (25 seconds) above basic parameters can be adjusted to the actual situation, the light changes with the actual law of the same intersection, the green light in the final five seconds, the yellow light is on, and then a red light, bright, not two fronts simultaneously bright green. (3) the green light at the time displayed on the digital display control. (4) can be controlled by a

自己编的C51串口，主要是协议，希望对大家有帮助-Own serial port of the C51, mainly the agreement, would like to help everyone

这是我自己编写的1602和18B20的原程序！以通过实验！-This is what I have written the original 1602 and 18B20 procedure! Through the experiment!

这也是MICROCHIP 单片机的C 编译器。 它集成了大部份的函数，使用非常方便。 用于多种PIC 系列单片机-It is C compiler of MICROCHIP single chip.It integrated most of functions,so it is convenient,it is used for kinds of PIC singlechip.

LT_1B msp430开发板例子程序－TB12-LT_1B msp430开发板例子程序－TB2

设计了一个单片机的原理图，并制作了相应的PCB版图，测试后程序运行正常-Designed a microcontroller schematics and produce the corresponding PCB layout, test program runs normally