STC Series 51 Single

简易谐波分析仪 -Simple Harmonic Analyzer

ARM程序，CM12864液晶显示屏程序，相信很多人需要吧，在LPC2103上测试通过。-ARM program, CM12864 LCD process, I believe many people need it, in the LPC2103 on the test.

用8051驱动240*128液晶的C51程序，控制器为T6963，由于代码比较大，试验时请用52 本程序移植性较好，已成功移植到MSP430上-8051 with 240* 128 LCD drive the C51 procedure, the controller for the T6963, as a result of relatively large code, test when you use 52 transplant procedures better, have been successfully transplanted into MSP430 on

录音笔的完整程序PIC18的C语言编写的，如果需要硬件电路图，请留言联系免费发送。-Recording pen complete C-language program PIC18

led大屏幕点阵 有程序参考，在灯饰上用处很大！-led large screen dot-matrix program has a reference on the use of lighting at great!

c8051f040ad实验,希望对大家有用-c8051f040ad experiment, in the hope that useful to everybody

Atmel Uart C51程序（timer2方式）-Uart (timer2 way)

我用单片机8952和电压比较器339做了一个简单的电容容量测量表，参数大 致如下： 电容测量范围为1pF-9999.99uF，最小分辨力为1pF。分为5个量程，可以自 动切换量程，也可手动切换。 另外，有简单的频率计功能，能测量0-60MHz的数字信号频率（TTL电平）； 还可以产生几个单点频率的方波信号（比如1KHz）。 采用1602LCD作为显示器；4个按键控制；使用24C01保存当前设置值，不用 每次开机重新设置。可单5V供电，也可9V交流供电 -I used the single-chip 8952 and the voltage comparator 339 to do a simple capacitance measurement table, parameters are as follows: capacitance measurement range 1pF-9999.99uF, the minimum resolution for the 1pF. Divided into five ranges, you can automatically switch range can also be manually switched. In addition, a simple frequency meter function, capable of measuring 0-60MHz frequency digital signal (TTL level) can also lead to several single-point-frequency square-wave signal (for example, 1KHz). 1602LCD used as a monitor 4 button control use 24C01 to preserve the current settings, do not reset each boot. Can be a single 5V power supply, 9V AC power supply can also be

按键控制步进电机正反转，此为电子显微镜载物台三维控制设计-Stepper motor control key positive

想使用宏晶科技ＳＴＣ系列的ＣＰＵ可以下载本文件，方便编程 -want to use technology-crystal STC series of CPU can download the paper to facilitate programming