单片机实现直流数控稳压电源,可调电压为0

USART以查询方式收发数据，接收发自电脑的数据，将其显示在LED上，并将接到到的数据减1后返回电脑-USART to send and receive data to query, receive from the bottom of the computer data that could be displayed in the LED, and will receive the data returned by a computer

串行通信程序，发送不是用中断方式，接收用中断方式，适用于程序的调试，液晶显示用的是1602-Serial communication program, sending instead of interrupt mode, receive mode using interrupted for Debugging, liquid crystal display using 1602

ARM 移植好的一种图形界面(440BX)-ARM transplant a good GUI (440BX)

schematic silver18F2620 (make silver card with PIC18F2620)

51LPC单片机用于控制交流电机, 内含C源程序.-Singlechip 51LPC for AC motor control, including C source code.

TG19264（点阵式无字库192*64）LED驱动，可在任列和行显示，可反白显示.-TG19264 (dot-matrix font free 192* 64) LED driver can be in any column and row shows that can be highlighted.

Motorola MCU HC08下的uCOSII移植源代码，刚刚完成。附用户应用程序测试，稍加修改可以增加自己功能。-HC08 Motorola MCU under uCOSII transplant source code, has just been completed. A user application procedures for the testing, a little change can increase their functionality.

本装置是一个以HT46R71D 为主芯片，配合传感器组成的汽车轮胎气压检测装 置，最终取高三位有效值于LCD 显示，有四种显示单位供切换（Psi、Bar、Kpa、 Kgf/cm2）。本装置仅为参考范例，使用时，为提高准确度，建议多量测些组数 据来构建Sensor Output Voltage - Discharge Time (V-T)表格，并作相应校准。-This device is a HT46R71D-based chips, with sensors detecting vehicle tire pressure devices, and ultimately take the high-three RMS in LCD display, there are four types of display units for switching (Psi, Bar, Kpa, Kgf/cm2). Only reference to an example of the device, when used to improve the accuracy of the proposed多量measured set of data to build more Sensor Output Voltage- Discharge Time (VT) forms, and the corresponding calibration.

此程序可以实现两个单片机之间的相互通信；串口采用方式1工作，10位异步接受和发送，波特率可变，由定时器1控制；且含有校验-This program can be achieved between the two microcontrollers communicate with each other serial port mode 1 using the work of 10-bit asynchronous receive and send, variable baud rate, from Timer 1 control and contains a checksum

hd7279的应用程序，实现了对八个二级管的控制。-hd7279 applications realize the eight diode control.