LPC1788，GPIO 中断

LPC2368外部中断的程序。非常好，基于IAR的

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4,每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

基于AT89C51使用ADC0832进行模数转换和显示。使用proteus+keil，有仿真原理图和C程序。-Based on AT89C51 using the ADC0832 analog to digital conversion and display. Use proteus+ keil, a simulation schematic diagram and C programs.

一个高级培训班的内部资料,非常宝贵,读者可以掌握嵌入式ARM基本思路-A high-level training of internal information, are very valuable, readers can grasp the basic ideas embedded ARM

STM32非固件库，实现功能：ADC通过DMA传输-Non-STM32 firmware library, implementation features: ADC through the DMA transfer

博创UP-NETARM2410-S实验箱源码：Exp7 can总线通讯实验-Fiberxon UP-NETARM2410-S experimental box source: Exp7 can bus communication experiment

4510 bootloader的实现与分析-4510 Bootloader the Implementation and Analysis

LINUX操作系统下的USB-uploader-USB-uploader in LINUX Operation System.

菲利普ARM开发板原理图，PDF-Philippe ARM development board schematics, PDF

三星ARM9 2410 SPI接口驱动源代码 for linux 2.4 内核-Samsung ARM9 2410 SPI interface driver source code for linux 2.4 kernel