FLASH的读写操作

STM32编译开发环境及仿真调试篇-野马学习笔记1-STM32 compiler development environment and simulation debugging chapter- Broncos Study Notes 1

该示例是 USB 到串口 （UART0） 为 LPC1788。 本示例描述如何在 LPC177x_8x 上使用 UART 接口。

keil lpc2138 epson6610 lcd source

这是看操作系统一书的一点笔记，希望对初学者有点帮助-This is the operating system look a little note book, I hope a little help for beginners

GPIO 的测试。 打开 LED，LED 测试 GPIO 关闭。 我上传这点。它不是对你有用。:))

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

arm bootloader的实现-arm of achieving Bootloader

本软件实现了FLASH底层驱动包括NOR FLASH与NAND FLASH-The software achieved a FLASH drive, including the bottom NOR FLASH and NAND FLASH

Samsung S3C2410 boootloader source code

关于44b0的i2c.rar iic相关的代码，希望能给你带来帮助 -I2c.rar iic on the 44b0-related code, I hope you will help