周立功的arm7源码－－－－好东西，一般的起始代码范例，觉得不错，推荐一下...

采用LPC的芯片做的气体排放检测,包括气体成分分析,数据的处理,数据传输给工作站.-LPC chips used to do the detection of gas emissions, including gas composition analysis, data processing, data transmission to the workstation.

89S51单片机并行驱动AD9851的程序，由于在选相中并没有KEILC 所以就选了C-C-89S51 parallel single-chip AD9851 driver of the process, as a result of the election phase and therefore did not KEILC selected C-C++

15寸，17寸液晶显示器驱动程序，带pcb图-15-inch, 17-inch liquid crystal display driver with pcb diagram

AT91M42800A的bootloader源代码，实现了中断处理以及中断矢量。-RISC Bootloader source code, achieve interruption of treatment and interrupt vectors.

ARM(LPC2214)模拟串口程序，通过定时器捕获比较功能产生模拟串口，波特率可以达到19200bps-ARM (LPC2214) simulation serial process, through timers have captured more functional simulation of serial ports, baud rate can be achieved 19200bps

EasyARM2131开发板源码之一-----------6.GPIO输出实验-LED数码管显示0-F字符，同时控制LED1、LED2、LED3、LED4显示对应的16进行值-EasyARM2131 one source development board----------- 6.GPIO experimental output- digital LED Display 0-F characters and control LED1, LED2, LED3, LED4 shows the corresponding values for 16

单片机C语言100例源代码基于PIC单片机C语言100例源代码基于PIC单片机C语言100例源代码基于PIC单片机C语言100例源代码基于PIC

ARM S3C2410处理器 rtc驱动程序 开发环境：ads1.2-ARM S3C2410 processor rtc driver development environment: ads1.2

ARM7开发板上做的U盘的源码,FAT文件系统,D12+51固件源码,用PDIUSBD12和K9F5608U0A设计USB移动闪存-ARM7 development board to do the U-source disk, FAT file system, D12+ 51 firmware source code, using PDIUSBD12 and K9F5608U0A Design USB Mobile Flash

uCOS移植范例,开发人员或嵌入式爱好者可以借鉴。-uCOS transplantation example, developers or embedded lovers can learn from.