基于UCOS操作系统的API函数,CHM格式，查阅非常方便

UCOS2外围接口程序源代码，大家看一下，共同分享-UCOS2 peripheral interface source code, we look into the shared

stm32-ucos wifi 驱动 88W8686芯片。WEP协议和不加密的通信调试通过。

ucos在8051单片机的移植 ，配合stc的st89c51,经测试可以运行(ucos transplant in 8051, with the stc' s st89c51, has been tested and can run)

mips下的ucos-Freezer CENTER

iar环境下移植ucos-ii到at91sam7s64-iar environment transplantation OUT-ii to at91sam7s64

second.rar 这个做的是一秒表计时程序，是用FPGA写的，里面代码完整，并带有文档报告-second.rar this is the one to do stopwatch timing procedures, FPGA is written inside the code integrity, and with the report document

ucosii的全部源码，学习ucosii的参考资料。-all codes of ucosii

1.板上的8 个按键分别分别代表数字1-8，按下一个按键将结果通过串口发送到PC机上显示； 2.使用两个定时器模块，分别定时为1ms 和100ms 产生中断，使用它们分别 产生1s的定时时间，将时间分别显示到数码管上； 3.外接PS/2小键盘，将按键的值通过串口显示到PC机上。(A panel of eight key representing the number 1-8 press a key the results sent through the serial port on a PC display (2) use two timer modules, respectively, of 1ms and 100ms timer generates an interrupt, use them, respectively, Produce the timing of the 1s, the time display to the digital control External PS/2 keyboard, the key value of displayed through the serial port to a PC.)

UCOS的源码，它的硬件基础是80186，只要你的电脑只要是INTEL的CPU，就可以在你的电脑上面正常运行，你也可以把它移植到你的MCU，所以这个源码是研究UCOS的最佳选择。-UCOS the source, and its hardware is based on 80,186, as long as your computer as long as it is INTEL" s CPU, on your computer in the normal operation of the above, you can transfer it to your MCU, so the source is to examine the UCOS the best choice.

UCOS在51上的移植,绝对经典！可以较少开发人员的工作量，提高开发效率！-UCOS in 51 of the transplant, absolute classic! Less development of the workload, to improve the efficiency!