NAT检测程序

使用串口控制百为stm32f103zet6开发板的四个LED*1111*开*0000*关，大概就是这样没有什么东西，主要是串口配置和解析数据

蜂鸣器模仿报警声，基于51单片机的蜂鸣器模仿报警声(The buzzer to imitate the alarm sound, 51 SCM buzzer alarm based on imitation)

button按下后，edit控件内容连续变化，button抬起后edit内容停止变化。自己做的例子，只以int数据为例。(button is pressed, edit control content changes continuously, button lift stops changing after edit content. Own example, an int data as an example only.)

基于非参数核密度估计的Copula函数选择原理.(Based on nonparametric kernel density estimation in the Copula function selection principle)

51单片机控制两脚机器人，六个舵机，走路程序(SCM 51 feet robot, six steering gear, walking program)

mpu6050，3 轴MEMS 陀螺仪，3 轴MEMS加速度计，整合性6轴运动处理组件电气及引脚说明，供硬件开发工程师参考。(Mpu6050, 3-axis MEMS gyroscope, 3-axis MEMS accelerometer, integrated 6-axis motion processing unit electrical and X, for hardware development engineers reference.)

我相信很多人和我一样，虽然经常使用MVC开发项目但是很少使用到HtmlHelper辅助方法，在这个demo中有辅助方法的建立，和辅助方法的调用，希望对你有所帮助。

多机通信，设计了一种基于MCS－51系列单片机AT89S52 的多机通信系统。当1号机与2号机通信时，1号单片机为主机，2号机为从机。主机通过串口向从单片机发送指定格式的数据，从单片机收数据并作出响应，从机通过LED数码管显示通信状态。1号单片机通过矩阵键盘控制通信过程与显示。这通信模式是主从模式，只能是主机发信息给从机。当1号机与3号机通信时，不存在主从机之分，是平权模式。1号机可以通过按键发信息给3号机，3号机也可以通过按键发信息给1号机，通过各自的数码管显示通信数据，LED灯显示通信状态。(Multi-machine communication, design a multi-machine communication system based on MCS-51 series single-chip AT89S52' s. When the 1st and the 2nd machine-machine communication, the 1st microcontroller host, the 2nd machine as a slave. Data sent to the host computer through the serial port specified format from SCM, SCM and respond to the received data from the slave via LED digital display communication status. 1 MCU control the communication process through the matrix keyboard and display. This mode of communication is a master-slave mode, the host can only send a message to the slave. When the 1st and the 3rd machine-machine communication, there is no slave master points, is affirmative mode. The 1st machine can send a message to the 3rd through the key machine, the 3rd machine can also send information via the button to the 1st machine, display data communication through their digital tube, LED lights display the communication status.)

Linux下BOASH公司m_can驱动(Linux BOASH m_can driver)

This program requires the MATLAB program in order to work, it is written for the SC140 digital signal processor.