在c51下液晶显示块LCD20040411的编程实例。

MPXA6115A程序测量大气压强 开发环境是在MSP430单片机下-Procedures for measuring atmospheric pressure MPXA6115A development environment is under the single-chip MSP430

步进电机控制程，加减速控制。行走步数控制-Stepper motor control process, acceleration and deceleration control. Control of walking a few steps

用C语言通过MCS-51 的并口控制打印 用于 沈阳新荣达电子 微型打印机-Using C language through the MCS-51 for the parallel port to control print Shenyang New??electronic micro-printer

这篇程序是我一个同学编的,并且已经应用到了二相步进电机(四线步进电机)上了.但是我认为此程序需要改进的地方有很多. -This procedure is a fellow student, I made and have been applied to a two-phase stepper motor (four-wire stepper motor) on. But I think this process needs to be improved where there are many.

凌阳 lcd 液晶显示程序 显示菜单命令-Sunplus lcd liquid crystal display program displays the menu commands

键盘扫描程序，初学者可以拿过来借鉴一下，程序里有详细注释!-Keyboard scanner, beginners can take over from you, the program, there are detailed notes!

做好的基于arm的lcd 的驱动程序，为毕业设计的一部分-Do a good job based on the arm of the lcd driver for the graduate part of the design

24c04读写程序，同时控制p10口的打开和关闭-24c04 read and write procedures for control of p10 at the same time the mouth opened and closed

利用c8051f020单片机进行串口通讯的软件程序，此型单片机将会成为8位机主流-by Using C8051f020 MCU for serial communication software program, this type of SCM will become mainstream eight-

Loops back EP2OUT to EP6IN and EP4OUT to EP8IN.