Cs8900网卡DSP驱动

利用单片机实现简单音乐发生器，可以尝试实践一下，比较简单-MCU use simple music generator, may try to practice that is relatively simple

用VC++6.0实现PC机与单片机之间的数据交换-VC 6.0 PC and SCM data exchange between the

周立功试验板DP51+程序-weeks meritorious test procedures plate DP51

18B20在MSP430上测试通过程序，有需要可以下载-18B20――program

用于无线POS 数据传输的原程序。通过调制解条芯片实现-POS data for wireless transmission of the original procedure. Solutions through modulation of the chip

FlashFlex51微控制器

基于AD89S52的AD9851控制驱动源程序。-Based on the AD9851 control AD89S52 drive source.

isd4003语音系统的回放和录音程序,测试成功,请有这方面经验的朋友多多指教-isd4003 voice playback and recording system procedures, the test was successful, have experience in this area exhibitions Friend

用单片机控制AD9852芯片生成信号的C程序-AD9852 chip with MCU control signals generated C program

这是参加电子设计大赛时的作品：红外遥控小车：用红外线通过一块AT89S52单片机发射信号即编码，并用红外接收头接收信号；接着再用另一块AT89S52单片机对红外发射出的信号编码进行解码，最后再用一块AT89S52单片机用解码所得码值编写程序后驱动步进电机。步进机功能启动后不仅能使受控小车向前后左右四个方向前进和转弯，而且还能控制小车再地上转动并留下方形或圆形等形状。-This is the time to participate in Electronic Design Contest works: infrared remote control car: Using infrared transmission signal through an AT89S52 microcontroller that is encoded and used infrared receiver to receive the first signal and then using the other an infrared emitting MCU AT89S52 code and decode the signal and finally an AT89S52 microcontroller then proceeds with the decoding key value of the preparation of procedures to drive a stepper motor. Stepper machine function activated not only make the car forward in a controlled direction and after about four turns, but also to control the car and then turned and left the ground such as square or round shapes.