如何在使用双数据指针我的语言在语言的硬件条件允许。

读取一个电机码盘信号，里面有对串口读写，对控制寄存器读写的代码。入门级！-read a motor encoder signals, and they read and write to serial port, the control register read and write code. Entry-level!

实现CAN总线的自收发！！ ！！1-Realize self-CAN bus transceiver! ! ! ! ! ! 1

2051的时钟程序问题2051clk-2051 clock procedure 2051clk

Verilog实现的DDS正弦信号发生器和测频测相模块，DDS模块可产生两路频率和相位差均可预置调整的值正弦波，频率范围为20Hz-5MHz，相位范围为0°-359°，测量的数据通过引脚传输给单片机，单片机进行计算和显示。-Verilog realize the DDS sine wave signal generator and frequency measurement module test phase, DDS module can generate both frequency and phase difference can be preset to adjust the value of sine wave, frequency range of 20Hz-5MHz, phase range of 0 °-359 ° , measurement data and transmit them to the single-chip pin, single-chip microcomputer to calculate and display.

大厦LED流水显示的程序，刚刚编完，可通过修改循环的次数和数据表来构成不同的显示效果-LED shows the procedure, the newly produced, cycle through changes in the number and composition of data tables show different results

这是sja1000的读写程序，和大家共享，有需要得打开-This is the SJA1000 literacy program, and everyone shared, there is a need to have open

Cygnal的F020采集电压信号送到液晶显示程序，经测试可用。-Cygnal

基于51单片机的液晶12864图片驱动及串行收发程序-Based on 51 single-chip LCD driver and serial 12864 picture transceiver procedures

51系列单片机在基本的开发例程，不错噢。-51 Series MCU in the development of basic routines, Oh well.

用pic18f8720做的电压采样处理程序，带了proteus仿真图的！-Pic18f8720 to do with the voltage sampling process, with the Proteus simulation chart!