读EEPROM内的数据并显示例程，供参考

延时采用指令延时的方法,通过改变系统时钟,改变延时的长短,用IOA口的低8位接的LED的闪烁显示出来-Delay the use of methods of instruction latency by changing the system clock, changing the length of delay, and low IOA I received 8 of the LED display flashes

这是一个有关于单片机屏幕显示的的源代码。真的不很不错。-This is a single-chip has on-screen display of the source code. Really not very good.

单片机控制步进电机加减速C语言源程序，通过不断改变定时器的定时初值来提高频率。-Single-chip stepper motor control acceleration and deceleration C language source program, by changing the timing timer to improve the frequency of the initial value.

仅供参考 仅供参考-only reference is for reference only reference is for reference only

读取韦根数据转换成RS232后传给上位机的程序-Wiegand reader into RS232 data to the host computer after the procedure

介绍了液晶显示模块基本原理及其技术特性，与单片机的进行接口的具体电路，同时给出了其编程方法和程序代码．-Introduced the basic principles of liquid crystal display module and its technical characteristics, and MCU interface to the specific circuit, at the same time gives the methods and procedures of its programming code.

sja1000与串口通信的程序，用串口通信助手可观察结果-SJA1000 with serial communication procedures, using serial communication assistant can be observed

基于msp430f149与CC2420的无线传感器网络平台，CC2420的C语言驱动代码-MSP430F149 and the CC2420-based wireless sensor network platform, CC2420 driver in C language code

LPC2119芯片中的RTC实时时钟程序，该程序实现LPC2119实时时钟功能。-LPC2119 chip real-time clock of the RTC program, the program is to achieve real-time clock function of LPC2119.

行走小绿人是用ht1632驱动程序由6*8*8块矩阵组成的24*16LED点阵屏幕来显示行走小绿人的动画。主芯片控制采矿ht4810a数据传输，