C language programming book. C51 MCU development tool

使用IAR编译器开发的ATmega128的程序 有串口通信 IO口控制 定时器 SPI接口等等功能的实现-Use IAR compiler development process ATmega128 serial communication port to control IO timer SPI interface functions and so on to achieve

本程序实现通过BDM方式访问MOTOROLA 9S12单片机EEPROM，可自动配置波特率，包含读、写、擦除三种功能。-This procedure, through BDM realize MOTOROLA 9S12 Singlechip access EEPROM, can automatically configure the baud rate, including reading, writing, erasing three functions.

利用串行驱动数码显示每位从0显示到F，到灭循环显示，要求1秒更新一次。-drive using serial digital display shows each from 0 to F, to eliminate cycle, a request updated seconds.

由SPCE061A控制的74HC164的驱动程序,一般用于串转并-by the 74HC164 SPCE061A control of the driver, the general and for Series switch

NTC热敏电阻测温，编译环境，AVR-G-NTC thermistor temperature measurement, the compiler environment, AVR-G

基于8051的单片机时钟源代码，可实现时间设置，闹钟等-Based on the 8051 single-chip clock source code, can be set-up time, alarm clock, etc.

PIC16机的代码范例， 想要试一试的朋友可以试验-PIC16 machine code examples, you want to try friends can test

由MSP430和CC1100+构成的无线传感器-By the MSP430 and CC1100+ Constitute a wireless sensor

使用汇编语言的89C2051键盘输入程序源码-The use of assembly language program the 89C2051 keyboard input source

这是通讯接口实验《异步串行通信实验》的原理程序，适合于那些上嵌入式系统、通信、计算机专业的人-This is the communication interface experiment, "asynchronous serial communications experiment," the principle procedures, suitable for those on embedded systems, communications, computer specialists in the