A RC531 Source Code for MIFARE card operations.

次程序为05全国电子设计大赛《悬挂系统》的源程序，供大家参考一下。-Meeting procedures for the 05 National Electronic Design Competition

红外信号测试软件-infrared signal testing software

SD卡读写程序 1. sdconfig.h: 该文件为SD卡读写模块配置头文件，用户可根据实际硬件条件进行修改. 2. SD目录: SD卡读写模块的全部文件,一般不用修改. 3. 建议sdconfig.h文件不要放于SD目录中，因为SD目录中的文件一般无须修改, 而sdconfig.h通常会有改动.-1. Sdconfig.h: The document for the SD card reader module configuration header files, the user hardware according to actual conditions can be modified. 2. SD directory: SD card reader module of all the documents, the general need not be amended. 3. Proposed sdconfig. h files directory should not be put in SD because SD files in the directory are not normally required to be amended and the changes are usually sdconfig.h.

ili9325TFT彩屏驱动器初始化源码-color ili9325TFT drive initialization source

msp430flash型单片机的封装库，呵呵，好东西-msp430flash- Packaging the MCU, what good things

I2C总线协议及其软件的实现，非常使用！！！！单片机用的-I2C bus protocol and software to achieve the very use! ! ! ! The MCU

用AVR单片机实现的乐曲编码程序，使用C语言写的-with AVR MCU music coding procedures, the use of the C language to write

LCD C 文件请看看是否合适、请给我加分 第一次上传文件-LCD C requested documents to see if appropriate, please give me extra points first upload documents

* 硬件结构： PA0-5对应６个ＬＥＤ数显管的位 ，PC0-7对应各ＬＥＤ数显管的段 ，PB4-7为键盘。 * 软件描述： 上电后，时钟从00.00.00（时/分/秒）自动走时，在走时状态时 ， 按PB4（设定 * 键）超过3秒可循环选择调整时间/工作参数 ，接着按PB5以确定选择的操作 ，进入调整操作后 ， * 按PB5选择欲调整参数，按PB6（增加键）完成调整参数操作 。按PB7，进入时控运行，PB1亮， * 再按PB7停止时控运行，回显走时。在定时到时，PB0点亮。- * Hardware architecture: PA0-5 corresponds 6 LED numbers to reveal the tube the position, PC0-7 corresponds each LED number to reveal the tube the section, PB4-7 is a keyboard. * Software description: After on electricity, clock from 00.00.00 (when/a minute/second) is in luck automatically, when is in luck the condition, according to PB4 (hypothesis * The key) surpasses for 3 seconds to be possible to circulate the choice time/operational parameter, then presses PB5 by to determine the choice the operation, after enters the adjustment operation * Wants according to the PB5 choice to adjust the parameter, (increases key) according to PB6 to complete the adjustment parameter operation.According to PB7, enters when controls the mov

单片机课程设计的LCD显示，附带有程序，仿真图，以及原理。-LCD display, there are procedures, simulation plans, as well as the principle of