lesson6

说明：  In order to solve the problem of low bandwidth utilization while the peak-to-average power ratio(PAPR) is reduced.

在VC++6.0中用MSComm控件编程，可以实现串口接(used in VC 6.0 MSComm programming, serial port access can be achieved)

完整的射频门禁程序源码包含rc522的驱动程序以及相应的显示程序(There had been many cases about RFID-based access control systems. In this paper, long-distance radio frequency technology was used and image-recognition technology was joined, these technologies were used to realize the automation of access management.)

运用matlab搭建了MIMO—OFDM系统，并仿真了该系统在awgn信道，平坦衰落和多径信道下的误码率。(Using matlab built a MIMO-OFDM systems, and simulation of the system in awgn channel, flat fading and multipath channel BER.)

说明：  D2D信道分配仿真，算法有启发式算法，最优算法等，仿真介入D2D对随干扰门限的变化等。(D2D channel allocation simulation, algorithm has heuristic algorithm, optimal algorithm and so on, simulation involves the change of D2D pair with interference threshold and so on.)

极化码的matlab实现，包括了完整的编码以及译码程序(polar coding and decoding)

易语言技能模拟技能CALL 还原VM 降低被检测几率()

it is a discription of starbucks supplychain managment system

说明：  对三路单音信号合成模拟话音信号进行PCM编码，并采用BPSK调制，通过AWGN信道，接收端采用BPSK相干解调和PCM译码，恢复原模拟信号(PCM coding is used to synthesize analog voice signals from three monotone signals. BPSK modulation is used to restore the original analog signals through AWGN channel. BPSK coherent demodulation and PCM decoding are used at the receiving end.)

接收端采用的算法和程序流程与发送端发送的OFDM符号的帧结构有关系。具体的帧结构，以及定时估计，频偏估计，剩余误差跟踪的算法可参考算法说明文档。这里对程序的流程进行说明。 首先根据短训练字的特性进行相关运算，进行信号到达检测，当检测到相关值大于门限一定次数后，认为有信号到达。然后根据长训练字的特性，进行相关运算，进行OFDM符号FFT窗口起始位置的估计。估计出FFT窗口的位置后，先在时域进行小频偏的估计，将两个长训练字进行小频偏补偿后，进行FFT运算，根据FFT运算的结果进行整数倍频偏的估计。这些参数估计完成后，就可以进行数据解调了。先对数据部分进行完整的频偏补偿，然后根据估计的FFT窗口位置进行FFT运算得到频域的数据，进行解调。然后在对应于导频的子载波位置上提取出导频信息，根据导频信息估计出剩余定时误差以及剩余的信道响应误差，将误差量送入环路进行跟踪。当收到所有数据后，重新回到信号到达检测状态，进行下一次信号到达的检测和信号接收。 (good)