MatLab_7_Programming

利用计算机完成控制系统的根轨迹作图，了解控制系统根轨迹图的一般规律，利用根轨迹进行系统分析。 (Using computer control system for the completion of the root locus mapping to understand the control system of the root locus of the general laws, the use of a systematic analysis of the root locus.)

matlab学习ppt，适于初学者学习交流(The book is intended for beginners)

此代码采用分布傅里叶法实现光纤通信中的色散和非线性特性传输。(This code simulates the NRZ code and decode in single mode fiber communication )

Block model of a phase locked loop implemented in Simulink. Step 2 of a series of 5 developed models.

从均匀PCM方法入手，产生一振幅为1和频率ω=1的正弦信号，分别用8电平和16电平进行量化，在同一坐标轴上绘出原信号和以量化信号，并比较这两种情况下的信号/量化噪声比(Starting from the uniform PCM method to produce a 1 amplitude and frequency ω = 1 of the sinusoidal signal, respectively, with 8 levels and 16 levels were quantified in the same plot of the original signal and the axes to quantify the signals, and to compare these two cases, the signal/quantization noise ratio)

matlab实现信号脉冲 matlab实现信号脉冲(Matlab signal pulse s ignal pulse Matlab)

水位水箱模糊控制，仿真效果好，可供模糊控制初学者学习。(Water tank fuzzy control, simulation results, and fuzzy control for beginners to learn.)

说明：  四个不同参数的ARMA过程的零极点图和功率谱密度曲线(Four different parameters of ARMA process of pole-zero diagram and power spectrum density curve)

多进制脉幅调制(M-PAM)和多进制脉位调制(M-PPM)的误码率分析(Multi-band pulse rate modulation (M-PAM) and the Multi-band pulse position modulation (M-PPM) BER analysis)

hmm speaker recognizer