srm

基于MATLAB中的Simulink模块中的双馈风机仿真示例，在此基础上重新设定合理的风机、配网及大电网的参数，设计加入四分量叠加法的风速模型。同时设计了110KV电网电压突然下降，在风电场并网点选择不同模式下的仿真结果分析和35KV配网发生三相短路故障时的风电机组输出特性仿真(Based on the simulation example of the doubly fed fan in the Simulink module in MATLAB, the parameters of the rational fan, distribution network and large power grid are reset on this basis, and the wind speed model with four component superposition method is designed. At the same time, the sudden drop of 110KV power grid voltage, simulation results analysis in different modes of wind farm and dot selection and the simulation of the output characteristics of the wind turbine when the three-phase short circuit fault occurs in the 35KV distribution network)

简易的蓄电池与超级电容混合储能系统。可以观测SOC值变换，电压电流变化等(A simple battery and super capacitor hybrid energy storage system, can achieve SOC monitoring, voltage and current monitoring, contrast.)

发动机流体计算、燃烧，方便修改，源码开放(Engine Liquid Computing, burning, to facilitate changes to open-source)

boost电路电压电流双环控制，参数选择(Double loop control of boost circuit)

福建PT风力发电机组日出力统计数据,可以根据该数据组，估计风速，做模型预测(PT wind turbine at Fujian output statistics data set according to the estimated wind speed, do model predictions)

Wind turbine simulation

单相全桥逆变电路，将直流逆变为交流，很好用的软件，提供给matlab新手使用(Single-phase full-bridge inverter circuit to DC to AC inverter, a very good software, made available to the novice to use matlab)

vumat 代码，用于abaqus explicit 金属塑性伤害模拟(vumat subrountine for abaqus explicit ,the hill parameter is to set 0.5 and 1.5 by default.)

说明：  基于PSCAD软件，对变压器的物理模型进行建模，供大家学习(Based on PSCAD software, the physical model of transformer is modeled for everyone to learn.)

说明：  计算电机启动时母线电压暂降的模型 对暂降幅值和相位进行了测量(A model for calculating bus voltage sag during motor starting the amplitude and phase of sag are measured)