GNNM

永磁同步电机模型参考自适应控制建模与仿真simulink，采用模型参考自适应( U6C38 u7C1 u6B1 u6B1 u7A1 u5A1 u5A2 U53C2 u8003 u81EA u9002 u5E94)

电力行业专用的潮流计算软件，能够执行复杂的系统潮流计算分析。(Power flow calculation of industry-specific software, can perform complex flow calculation analysis.)

The base-case HVDC Benchmark CIGRE, implemented on ATP Draw software.

大地电磁二维正演程序Matlab开发的两种模式TM和TE模式(Magnetotelluric 2D forward the program Matlab development of the two modes of TM and TE mode)

分别对速度、磁场两个分量进行独立控制。通过控制转子磁链，以转子磁通定向，然后分解定子电流而获得转矩和磁场两个分量，经坐标变换，实现正交或解耦控制(The velocity and magnetic field components are controlled independently. By controlling the rotor flux, the rotor flux is oriented, and then the stator current is decomposed to obtain two components of the torque and magnetic field. Orthogonal or decoupling control is realized by coordinate transformation.)

说明：  本程序用于“多个火电机组、储能电站在电网调度指令的引导下的出力联合优化”，调度间隔为1min（可修改）。(This program is used for "joint optimization of output of multiple thermal power units and energy storage power stations under the guidance of power grid dispatching instructions". The dispatching interval is 1min (modifiable).)

基于PSCAD的风电厂建模，包含不同子模块，可模拟风电厂的实际运行(The wind power plant model based on PSCAD includes different sub-modules, which can simulate the actual operation of the wind power plant.)

已知压气机的状态参数可求解出该状态下的特性线(if the state of compressor had been knowed,the code is used to calculate the charcter line)

用拟牛顿法求非线性方程组 fi( x1, x2, ?, xn ) = 0, i = 1, 2, ?, n 的一组实数解。(A quasi-Newton method is used to find a set of real solutions of the nonlinear equations.)

双馈风机，含轴系模型，变流器简化为受控电压源，记得先打开坐标库。(DFIG. Shaft model included. Converters are simplified as controllable voltage source.)