登录
首页 » C++ » STM32103制作的数控电源源代码

STM32103制作的数控电源源代码

于 2020-03-10 发布
0 253
下载积分: 1 下载次数: 5

代码说明:

说明:  用STM32103单片机,采用数码管显示电流、电压的数控电源。对学习STM32单片机编程和DIY数控电源很有实用价值。(With STM32103 single chip microcomputer, digital tube is used to display current and voltage. It is very useful for learning STM32 single chip computer programming and DIY numerical control power supply.)

文件列表:

STM32103制作的数控电源源代码\CF-power2.axf, 275352 , 2012-02-06
STM32103制作的数控电源源代码\CF-power2.hex, 63493 , 2012-02-06
STM32103制作的数控电源源代码\CF-power2.htm, 95705 , 2012-02-06
STM32103制作的数控电源源代码\CF-power2.lnp, 361 , 2012-02-06
STM32103制作的数控电源源代码\CF-power2.map, 138522 , 2012-02-06
STM32103制作的数控电源源代码\CF-power2.plg, 207 , 2013-05-13
STM32103制作的数控电源源代码\CF-power2.sct, 479 , 2010-05-15
STM32103制作的数控电源源代码\CF-power2.tra, 1273 , 2012-02-06
STM32103制作的数控电源源代码\CF-power2.uvgui.best, 74190 , 2013-05-13
STM32103制作的数控电源源代码\CF-power2.uvgui.tcf, 137854 , 2012-02-06
STM32103制作的数控电源源代码\CF-power2.uvopt, 10942 , 2013-05-13
STM32103制作的数控电源源代码\CF-power2.uvproj, 15823 , 2013-05-13
STM32103制作的数控电源源代码\CF-power2_Target 1.dep, 1474 , 2013-05-13
STM32103制作的数控电源源代码\disp.crf, 152005 , 2012-02-06
STM32103制作的数控电源源代码\disp.d, 1611 , 2012-02-06
STM32103制作的数控电源源代码\disp.o, 172124 , 2012-02-06
STM32103制作的数控电源源代码\ExtDll.iex, 19 , 2012-01-05
STM32103制作的数控电源源代码\i2c_driver.crf, 152448 , 2012-02-06
STM32103制作的数控电源源代码\i2c_driver.d, 1794 , 2012-02-06
STM32103制作的数控电源源代码\i2c_driver.o, 177880 , 2012-02-06
STM32103制作的数控电源源代码\main.crf, 164503 , 2012-02-06
STM32103制作的数控电源源代码\main.d, 1680 , 2012-02-06
STM32103制作的数控电源源代码\main.o, 201076 , 2012-02-06
STM32103制作的数控电源源代码\Src\Disp.C, 284 , 2010-05-15
STM32103制作的数控电源源代码\Src\Disp.H, 426 , 2010-05-15
STM32103制作的数控电源源代码\Src\I2C_Driver.c, 6392 , 2010-06-29
STM32103制作的数控电源源代码\Src\I2C_Driver.h, 771 , 2010-06-29
STM32103制作的数控电源源代码\Src\main.c, 35109 , 2013-05-13
STM32103制作的数控电源源代码\Src\MainDef.h, 1209 , 2010-06-15
STM32103制作的数控电源源代码\Src\StdPeriph_Ini.c, 20815 , 2010-09-23
STM32103制作的数控电源源代码\Src\stm32f10x_it.c, 38303 , 2010-10-20
STM32103制作的数控电源源代码\Src\stm32f10x_it.h, 5284 , 2010-10-14
STM32103制作的数控电源源代码\Src\user.h, 602 , 2010-06-16
STM32103制作的数控电源源代码\stdperiph_ini.crf, 156712 , 2012-02-06
STM32103制作的数控电源源代码\stdperiph_ini.d, 1899 , 2012-02-06
STM32103制作的数控电源源代码\stdperiph_ini.o, 179616 , 2012-02-06
STM32103制作的数控电源源代码\STM32F10x.d, 26 , 2012-02-06
STM32103制作的数控电源源代码\STM32F10x.lst, 35283 , 2012-02-06
STM32103制作的数控电源源代码\STM32F10x.o, 5644 , 2012-02-06
STM32103制作的数控电源源代码\STM32F10x.s, 11307 , 2009-05-07
STM32103制作的数控电源源代码\stm32f10x_it.crf, 160673 , 2012-02-06
STM32103制作的数控电源源代码\stm32f10x_it.d, 1962 , 2012-02-06
STM32103制作的数控电源源代码\stm32f10x_it.o, 197520 , 2012-02-06
STM32103制作的数控电源源代码\Src, 0 , 2020-03-10
STM32103制作的数控电源源代码, 0 , 2020-03-10

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • KEY
    基于STM32开发板的按键实验,C程序,是关于STM32底层开发,对于初学者很有帮助(Key experiments based on STM32 development board, which explained in detail on the bottom of the development STM32 helpful for beginners)
    2012-12-11 11:45:16下载
    积分:1
  • led
    消毒櫃LED显示原理图(Sterilizer LED display schematic)
    2009-01-09 20:57:20下载
    积分:1
  • main
    风机控制器智能程序4,请大家自己使用,千万不外传!(Intelligent fan controller program 4, let us own use, do not Gaiden!)
    2009-12-24 12:16:56下载
    积分:1
  • STM32-USART-send-and-receive-data-
    本程序目的是提供使用stm32串口收发一帧数据的一种方法,采用中断方式接受和发送,每进一次中断接收或发送一字节,可以实现pc机与板子通信或板子与板子间通信。注意本程序中外接高速晶振为12M赫兹,而大部分板子为8M赫兹,本程序所用芯片是stm32RBT6(The purpose of this procedure is to provide a method of using STM32 serial port to send and receive a data, using interrupt mode to receive and send, every one into the time interrupt receiving or sending a byte, can realize PC and the communication or board and board communication. Note that this procedure the external high-speed crystal oscillator for the 12M Hz, while the majority of board is 8M Hz, the chip used in this procedure is stm32RBT6)
    2020-07-31 10:18:38下载
    积分:1
  • Msp430-based-oscilloscope
    基于msp430g2553的简易示波器 无需外设.超低功耗 诺基亚5513显示 (Msp430 based oscilloscope)
    2014-01-12 12:16:42下载
    积分:1
  • Code
    说明:  设计一个正弦信号发生器,使用凌阳公司的16位单片机SPCE061A作为中央控制器,结合DDS芯片AD9850,产生0~15MHz频率可调的正弦信号,正弦信号频率设定值可断电保存;使用宽频放大技术,在50Ω负载电阻上使1K~10MHz范围内的正弦信号输出电压幅度VP-P=6V±1V;产生载波频率可设定的FM和AM信号;调制信号为1KHz的正弦波,调制信号的产生采用DDS技术,由CPLD和Flash ROM加上DAC进行直接数字合成;二进制基带序列码由CPLD产生,在100KHz固定载波频率下进行数字键控,产生ASK,PSK信号。(Design of a sinusoidal signal generator, the use of Sunplus 16-bit MCU SPCE061A as the central controller, combined with DDS chip AD9850, have adjustable frequencies 0 ~ 15MHz sinusoidal signal, sinusoidal signal frequency settings can be stored power using broadband amplification, in a 50Ω load resistor to 1K ~ 10MHz sinusoidal signal within the output voltage amplitude VP-P = 6V ± 1V generating the carrier frequency of the FM and AM can be set signal 1KHz sine wave modulation signal, modulated signal generation using DDS technology, coupled by the CPLD and Flash ROM DAC for direct digital synthesis binary baseband sequence code generated by the CPLD in a fixed carrier frequency 100KHz digital keying, resulting in ASK, PSK signals.)
    2011-02-22 12:12:06下载
    积分:1
  • STC_IR_REMOTER
    说明:  使用P3.2外部中断下降沿触发, 对NEC红外编码方案进行解码。 单片机晶振12M, 22pf匹配电容 测试遥控器为淘宝购买, 淘宝输入 ‘红外遥控器’ 即可, 不到2元一个。 单片机用的是 STC 的 12C5A60S2, 使用串口下载烧录程序。 因为使用的12M晶振, 不是11.0592,所以使用单片机内部的专用波特率发生器, 最高9600bps,再高就乱码误码比较大了。 红外接收电路1838T 3脚一体化, 使用数据手册里的推荐电路, 自行百度。(NEC infrared decoder program based on STC MCU using C language. MCU model: STC12C5A60S2 CRYSTAL: 12 M INFRARED RECEIVER MODEL: 1838T)
    2020-09-04 14:54:57下载
    积分:1
  • WaTemp
    这是个温度检测程序,10K的温度探头,基于STM32F103(This is a temperature detection program, 10K temperature probe)
    2019-03-19 10:26:24下载
    积分:1
  • Visual_Studio_2010_Shortcuts
    Microsoft Visual Studio 2010 Express 快速功能鍵(Microsoft Visual Studio 2010 Express Keybinding Brochures)
    2014-01-21 14:51:30下载
    积分:1
  • sample_UART
    瑞萨RL78/G13UART串口通讯例程(Renesas RL78/G13UART serial communications routines)
    2020-12-18 15:19:10下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载