Protograph_EXIT_chart-master

汽车诊断协议 基于UDS的网络层源代码(Network Layer Source Code Based on UDS for Automobile Diagnosis Protocol)

说明：  ethernet mac vhdl verilog basic

OFDM（正交频分复用）系统以其抗多径衰落和较高的频带利用率，得到了众多领域的广泛应用。本文就OFDM系统中关键技术之一的信道估计技术进行了介绍。并分别叙述了OFDM系统和信道估计的意义，归纳了信道估计的分类，最后介绍了MMSE、LS及其改进信道估计算法并仿真出结果。(OFDM（orthogonal frequency division multiplexing) has been widely used in many areas for its good resistance to multipath fading and high bandwidth efficiency.In this paper,channel estimation,which is one of the key technologies in OFDM systems,were introduced. Then we discuss the significance of the channel estimation and the classification of channel estimation.Finally,we study the algorithms of channel estimation such as MMSE,LS and LMMSE,and further get the simulation results. )

this file is used to activate app on startup of nokia mobile.

iec103 规约上位机源代码，喜欢的就下吧。(iec103 Statute of the host computer source code, like on the next bar.)

在信号发送后，接收方需要实现位同步才能正确解码(after signal is sent, receiver need bit syn to decode correctly)

易语言技能模拟技能CALL 还原VM 降低被检测几率()

Dymo routing protocol

实现信号处理中QAM调制、过信道、解调部分。其中QAM调制部分可改符号点数，M阶数，信道加高斯白噪声、时延、多径，调制解调均有星座图。通过本代码，可学习QAM调制解调，或者通信系统的知识。(To achieve QAM modulation, signal processing over channel, a demodulation section. QAM modulation section can be changed symbolic points M order channel additive white Gaussian noise, delay, multipath, the modem has constellation diagram. QAM modulation and demodulation, or communication system knowledge through this code, you can learn.)

（1）请推导出单径瑞利信道中的BPSK相干解调的理论误码率性能，并画出比特信噪比与误码率的关系曲线。 （2）在单径瑞利信道中，请设计一种时分的导引辅助的信道估计方法，用Simulink进行仿真，测量BPSK的误码率性能，画出比特信噪比与误码率的关系曲线，并与(1)的曲线进行对比。 ((1) derived from single-Path Rayleigh channel coherent demodulation of BPSK theoretical bit error rate performance and draw-bit signal to noise ratio and bit error rate curve. (2) in a single Path Rayleigh channel, please design a guided night-assisted channel estimation methods, using Simulink simulation, surveying BPSK BER performance, drawn-bit signal to noise ratio and bit error rate curve, and with (1) comparing the curve.)